R K Manikandan

R K Manikandan


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 October 2022 in Materials
Verified
Journal Article
Open access
PDF file
RSR. Sujitha
R. Sujitha
NSN. Sunmathi
N. Sunmathi
RMR K Manikandan
R K Manikandan
APArunprasad prasad
Arunprasad prasad
SRS. Rajkumar
S. Rajkumar
EEElsayed Mohamed Tag Eldin
Elsayed Mohamed Tag Eldin
In the construction of steel structures, the two most common types of structural members are hot-formed and cold-formed members. This paper mainly describes the analytical and experimental research on the strength and characteristics of CFS bolted built-up sigma sections having different structural arrangements under bending. The cross-sectional dimensions for the parametric study were selected by the sizes available in the market. In this paper, ANSYS workbench software was used to perform FE modeling and observe the local, flexural, and interaction of these buckling. Then, experimental study was performed by varying the arrangement of open section beams between face-to-face and back-to-back, connected using bolts or fasteners different spacings. Further, we conducted bending tests on cold-formed steel built-up members having simple edge stiffeners in the middle. Comparing both analytical and experimental studies, the results indicate that the back-to-back connected built-up beam section provides a flexural capacity higher than the face-to-face built-up section. Moreover, increasing the bolt spacing enhanced the load-carrying capacity of back-to-back sigma section built-up beams. It has also been discovered that the flexural strength of beams is primarily determined by bolt spacing or itsposition.

1 January 2023 in Matéria (Rio de Janeiro)
Verified
Journal Article
Open access
PDF file
RMR K Manikandan
R K Manikandan
RVRamasamy Vasudevan
Ramasamy Vasudevan
Concrete, a vital material in construction, is facing challenges in enhancing its strength and durability. Researchers are exploring innovative approaches, such as using Fibre Reinforced Polymer (FRP) composites, to improve these properties. Structural flaws are often found during evaluations of existing buildings, especially older ones that may benefit from retrofitting. In this study, Manufactured sand was tested as a replacement for fine aggregate in concrete mixes to strengthen the mixes. The study utilized response surface methodology to predict the strength properties of sustainable Concrete mixes based on compressive strength. The flexure of reinforced concrete beams was evaluated using chopped strand mat (CSM) and glass-fiber reinforced plastic (GFRP) laminates. The study tested five RC beams using a 4-point bending configuration, with one beam serving as the control and the other four strengthened with FRP laminates. The results showed successful improvement in load-bearing capacity with GFRP + CSM laminates. However, thicker FRP sheets were not recommended as they can impact flexural strength. The GFRP + CSM enhanced beam achieved a 107% increase in ultimate load compared to the non-strengthened beams, according to experimental results. The strengthened beam had a greater rise load-carrying capability of 115 kN than the unstrengthen beam.