The effect of single-sided and double-sided harmonic surface waviness on the film thickness, pressure, and temperature oscillations in an elastohydrodynamically lubricated eccentric-tappet pair has been investigated in relation to the eccentricity and the waviness wavelength. The results show that, during one working cycle, the waviness causes significant fluctuations of the oil film, pressure, and temperature, as well as a reduction in minimum film thickness. Smaller wavelength causes more dramatic variations in oil film. The fluctuations of the pressure, film thickness, temperature, and traction coefficient caused by double-sided waviness are nearly the same compared with the single-sided waviness, but the variations are less intense.
Using an optical interferometric technique, the grease film distribution under a pure rolling reciprocating motion is observed on a ball-disk test rig, to explore the transient response of grease, which is expected to fill the contact with thickener fiber and run for a long time under steady-state conditions. It is found that the reciprocating motion reduces the accumulation of the thickener fiber gradually with time. The maximum film thickness forms around the stroke ends. After 1,000 working cycles, very severe starvation occurs so that either the central or minimum film thickness becomes nearly constant over one working period. Thus, the life of grease lubrication under a transient condition is far below that under steady-state conditions. However, it is also found that by selecting a smaller stroke length, the thickener fiber spreads out in the contact instead of being removed from the contact at the 1,000th working period. When increasing the maximum entraining speed of the reciprocating motion to a certain value, during which the thickener fiber is not expected to accumulate under a steady-state condition, severe starvation occurs very quickly, causing surface damage.
The influences of a single bump (dent) or regularly arranged bumps (dents) on the film thickness in impact circular elasthydrodynamic lubrication (EHL) contacts lubricated with a Newtonian lubricant are investigated numerically. It has been found that the deformation of the bump or the dent at the contact center depends mainly on the macroscopic pressure distribution produced between the smooth surfaces by impact. The macroscopic pressure distribution is influenced by the initial impact gap, the loading speed, and the mass of the moving body. The central bump or dent hardly deforms when the initial impact gap or the base radius of the bump or dent is small. When the initial impact gap is large and the radius of the base of the central bump is not so small, the oil is entrapped in the bump, and micro-dimple is formed. The deformation of noncentral bumps or dents is mainly influenced by the film profile under conditions of smooth surfaces.
A high-order polynomial gas distribution cam mechanism is investigated theoretically from the viewpoint of thermal elastohydrodynamic lubrication (EHL). First, a cam with a larger base circle radius is employed, which results in slide–roll ratio 2.0 < S < 9.0 when the two surfaces move oppositely. The pressure, film thickness, and temperature profiles at a number of angular positions of the cam are presented, together with the isothermal results. The comparison between thermal and isothermal oil characteristics is also shown. It is revealed that the isothermal analysis partly overestimates the actual film thickness and it also misses some essential local phenomena. Second, a cam with a smaller base circle radius is studied, which leads to drastic variations in the slide–roll ratio which encounters four times’ occurrences of infinity in one working period. The pressure, film thickness, and temperature profiles at some angular cam positions together with the oil characteristics are given, showing much dramatic variations. A very small film thickness is observed at the contact of the tappet with the start of the cam basic segment, which suggests a possible risk of direct contact of both surfaces.