In this article, the concurrent optimal design of a planar five-bar parallel robot for a high-speed pick and place task is considered. A trade-off between trajectory tracking, energy consumption and deformation of the flexible links is sought. Due to the high-speed operation, the minimization of the vibratory effect is considered since the design stage. Thus, the design is stated as a non-linear multi-objective dynamic optimization problem that is solved through the Differential Evolution (DE) algorithm, as well as, feasibility rules for constraints handling. Mechanical structural variables that modify the inertial parameters of the rigid and flexible links, as well as, control variables related to gains of a PID controller are considered as independent variables. This problem is subject to maximum torque that each motor could provide; inherent constraints for link manufacture; dimensional synthesis; Grashof’s criterion and initial and boundary conditions. Results show that it is possible, despite the vibrational phenomenon, to reduce the energy consumption without loss of precision through an appropriate mass balance of the actuated links.
This paper aims to concurrently select and control off-the-shelf BLDC motors of industrial robots by using a synergistic model-based approach. The BLDC motors are considered with trapezoidal back-emf, where the three-phase (a,b,c) dynamics of motors are modeled in a mechatronic powertrain model of the robot for the selection and control problem, defining it as a multi-objective dynamic optimization problem with static and dynamic constraints. Since the mechanical and electrical actuators’ parameters modify the robot’s performance, the selection process considers the actuators’ parameters, their control input, operational limits, and the mechanical output to the transmission of the robot joints. Then, three objective functions are to be minimized, the motor’s energy consumption, the tracking error, and the total weight of installed motors on the robot mechanism. The control parameterization approach via a cascade controller with PI controllers for actuators’ voltage and a PID controller for actuators’ torque is used to solve the multi-objective dynamic optimization problem. Based on simulations of the closed-loop system, a Pareto front is obtained to examine trade-offs among the objective functions before implementing any actuators in the existing robotic system. The proposed method is tested on an experimental platform to verify its effectiveness. The performance of an industrial robot with the actuators originally installed is compared with the results obtained by the synergic approach. The results of this comparison show that 10.85% of electrical power can be saved, and the trajectory tracking error improved up to 57.41% using the proposed methodology.
In this paper, a concurrent structure-control design is applied to a five-bar parallel robot in order to minimize the tracking error in a high-speed task. The high power necessary to perform the task leads to a challenging problem in handling a physical constraint on the maximum torque as well as on the structure-control design parameters. Three constraint-handling techniques, the feasibility rules, ε-constrained method and stochastic ranking have been used to analyze how the design changes as the torque constraint are reduced. Studying torque reduction is important from the energy consumption point of view, as well as the use of lighter and cheaper motors. In addition, a comparison among the three constraint-handling techniques is implemented so as to observe the performance and quality of the obtained results. The final results suggest that stochastic ranking method always obtains feasible and successful solutions in all proposed torque limits.
1 September 2023 in Expert Systems with Applications
The objective of this work is to design a rehabilitation mechanism for the index finger that can replicate the finger’s natural movements in the sagittal plane; this mechanism must also be able to adapt to an individual’s anthropometric dimensions. The personalization of the mechanism is made through a parametric model assisted by computer-aided design software. An infrared motion capture system is used to validate the natural finger movements, comparing them to the ones generated by the parametric designed mechanism. The replication of natural finger movements with this mechanism is possible due to the use of virtual centers and the employment of two degrees of freedom. One degree of freedom is proximal phalanx flexion-extension, and the other one is the middle-distal phalanges conjoined movement. The replication of natural motions and the use of personalization techniques offer three main advantages: a diverse set of rehabilitation exercises, an increase in the range of motion of the finger compared to other designs in the literature and the short construction time required for the rehabilitation device.