In this study, we present a polarization-multiplexed, erbium-doped dual-comb fiber laser based on an all-polarization-maintaining cavity configuration. We observed that the dual-comb fiber laser easily realized the self-starting mode-locking operation due to the non-linear amplifying loop mirror (NALM) with a non-reciprocal phase shifter. Furthermore, owing to the sharing of the NALM part, the two outputs from this laser configuration had similar center wavelengths, with small different repetition rates (∆f_rep). In the free-running operation, the standard deviation of relative stability for Δf_rep of 2.09 kHz was measured to be 1.59 Hz, and the full width at half-maximum of the relative beat note between the two frequency combs in the optical frequency domain was approximately 1 kHz. These results show that the two frequency combs from this laser configuration have high relative stability and mutual coherence.

We demonstrate a low phase noise all polarization-maintaining (PM) Er-fiber optical frequency comb (OFC) with low phase noise, which is synchronized to the hydrogen maser clock (HMC) using the 18th harmonic of the repetition rate for tight phase locking. The instability of the locked carrier envelope offset frequency is 1.24 × 10⁻¹⁸@1 s, the phase noise of the OFC is −96 dBc/Hz at 1 Hz offset, and the corresponding RMS timing jitter of the repetition rate is 62 fs (1 Hz–1 MHz). The residual frequency instability of the repetition rate (200 MHz) is 1.46 × 10⁻¹⁴@1 s, and the residual phase noise of the OFC normalized to 10 MHz is −138 dBc/Hz at 1 Hz offset and declines to about −160 dBc/Hz at the far-end, much lower than that of the HMC (−122 dBc/Hz at 1 Hz and −156 dBc/Hz at the far-end).

Microwave sources based on ultrastable lasers and optical frequency combs (OFCs) exhibit ultralow phase noise and ultrahigh-frequency stability, which are important for many applications. Herein, we present a microwave source that is phase-locked to an ultrastable continuous-wave laser, with a relative frequency instability of 7 × ${10}^{-16}$ at 1 s. An Er:fiber-based OFC and an optic-to-electronic converter with low residual noise are employed to confer optical frequency stability on the 9.6 GHz microwave signal. Instead of using the normal cascaded Mach–Zehnder interferometer method, we developed a microwave regeneration method for converting optical pulses into microwave signals to further suppress the additional noise in the optic-to-electronic conversion process. The microwave regeneration method employs an optical-to-microwave phase detector based on a fiber-based Sagnac loop to produce the error signal between a 9.6 GHz dielectric resonator oscillator (DRO) and the OFC. The 9.6 GHz microwave (48th harmonic of the comb’s repetition rate) signal with the frequency stability of the ultrastable laser was achieved using a DRO that was phase-locked to the optical comb. Preliminary evaluations showed that the frequency instability of the frequency synthesizer from the optical to the 9.6 GHz microwave signal was approximately 2 × ${10}^{-15}$ at 1 s, the phase noise was $-106$ dBc Hz⁻¹ at 1 Hz, and the timing noise was approximately 9 as Hz^−1/2 (phase noise approx. $-125$ dBc Hz⁻¹). The 9.6 GHz signal from the photonic microwave source exhibited a short-term relative frequency instability of 2.1 × ${10}^{-15}$ at 1 s, which is 1.5 times better than the previous results.

This paper presents a combined theoretical and experimental method for noise suppression in the repetition frequency (f_r) locking of erbium-doped fiber optical frequency combs (OFCs). This study proposed a novel mathematical model to bridge the noise relationship of f_r between the free-running and locked modes, and analyzed this relationship from two perspectives: the additional phase noise and the frequency stability. In addition, to integrate theoretical modeling with experimental validation, this study designed f_r locking strategy that uses a phase-locked loop (PLL) with PFD + PIID (a phase frequency detector and a proportional, first-order integer, second-order integer, first-order differential controller). Under synchronization of the f_r with a microwave reference (REF), this study achieved OFC additional frequency stabilities of 2.81 × 10⁻¹⁵@1 s and 8.08 × 10⁻¹⁹@10,000 s at 200 MHz fundamental frequency locking and 4.25 × 10⁻¹⁶@1 s and 1.91 × 10⁻¹⁹@10,000 s at 1200 MHz harmonic locking. The simulated and experimental results are in good agreement, confirming the consistency of the theoretical model and experiment. This work provides a reliable theoretical model that can be used to predict stability for OFC locking and significantly improves the additional frequency stability of OFCs.

We demonstrated an all-polarization-maintaining (PM), multi-branch optical frequency comb based on an all-fiber configuration. To achieve fiber noise cancellation, we aligned the beat note of the out-of-loop branch with that of the in-loop branch by phase-locking both branches to a common 1550 nm ultra-stable laser. To further assess the out-of-loop frequency instability of the constructed fiber comb, we heterodyned it with another quasi-identical fiber comb. Thanks to effective fiber noise cancellation and a small difference in out-of-loop fiber lengths, the frequency instability of a single comb reached an exceptional level of 2.26 × 10^-17 at 1 s and 8.4 × 10^-20 at 4000 s. © 2026 Chinese Optics Letters