We evaluate the Brillouin frequency shift (BFS) determination error when utilizing the Brillouin phase spectrum (BPS) instead of the Brillouin gain spectrum (BGS) in BOTDA systems. Systems based on the BPS perform the determination of the BFS through a linear fit around the zero de-phase frequency region. An analytical expression of the error obtained in the BFS determination as a function of the different experimental parameters is provided and experimentally validated. The experimental results show a good agreement with the theoretical predictions as a function of the number of sampling points, signal-to-noise ratio (SNR) and Brillouin spectral linewidth. For an equal SNR and linewidth, the phase response only provides a better BFS estimation than the gain response when the fit is performed over a restricted frequency range around the center of the spectral profile. This may reduce the measurement time of specific BOTDA systems requiring a narrow frequency scanning. When the frequency scan covers most of the Brillouin spectral profile, gain and phase responses give very similar estimations of the BFS and the BPS offers no crucial benefit.

We demonstrate a simple scheme that allows performing distributed Brillouin phase spectrum (BPS) measurements with very high spatial resolution ($\sim 7\mathrm{cm}$) over long ($\sim 4.7\mathrm{km}$) optical fibers. This is achieved by inserting a Sagnac interferometer (SI) in a Brillouin optical correlation domain analysis (BOCDA) configuration. Over its already-presented time-domain equivalent (SI-BOTDA), this approach reduces the main source of noise (coherent backscatter noise) thanks to the low-coherence nature of the used signals. On the other hand, over the most usual schemes used for distributed BPS measurements, this implementation presents the key advantage of not requiring high-bandwidth detection or complex modulation while reaching unprecedented values of spatial resolution and number of resolved points for this type of measurement. Thanks to the linear dependence of the BPS feature around the Brillouin frequency shift, this scheme could also have the advantage of requiring shorter scanning ranges than amplitude-based configurations.

Geographical Information Systems (GIS) are often used to assess and monitor the environmental impacts caused by mining activities. The aim of this work was to develop a new application to produce dynamic maps for monitoring the temperature variations in a self-burning coal waste pile, under a GIS open source environment—GIS-ECOAL (freely available). The performance of the application was evaluated with distributed temperature measurements gathered in the S. Pedro da Cova (Portugal) coal waste pile. In order to obtain the temperature data, an optical fiber cable was disposed over the affected area of the pile, with 42 location stakes acting as precisely-located control points for the temperature measurement. A monthly data set from July (15 min of interval) was fed into the application and a video composed by several layouts with temperature measurements was created allowing for recognizing two main areas with higher temperatures. The field observations also allow the identification of these zones; however, the identification of an area with higher temperatures in the top of the studied area was only possible through the visualization of the images created by this application. The generated videos make possible the dynamic and continuous visualization of the combustion process in the monitored area.

The combustion of coal wastes resulting from mining is of particular environmental concern, and the importance of proper management involving real-time assessment of their status and identification of probable evolution scenarios is recognized. Continuous monitoring of the combustion temperature and emission levels of certain gases allows for the possibility of planning corrective actions to minimize their negative impact on the surroundings. Optical fiber technology is well suited to this purpose and here we describe the main attributes and results obtained from a fiber optic sensing system projected to gather data on distributed temperature and gas emissions in these harsh environments.

In this Letter, we present and demonstrate a novel technique for distributed measurements in Brillouin optical time-domain analysis based on the use of the nonlinear phase-shift induced by stimulated Brillouin scattering. Employing a Sagnac interferometer (SI), the position-resolved Brillouin phase-shift spectrum (BPS) along the fiber can be obtained, benefiting from the sensitivity to nonreciprocal phase-shifts of the SI scheme. This proposal simplifies the existing methods to retrieve the BPS distribution along an optical fiber since phase modulation, filtering, and high-bandwidth detectors are not required. The fundamentals of the technique are described theoretically and validated through numerical simulations and experimental measurements.