We demonstrate experimentally that it is possible to control optically the group velocity of an optical pulse as it travels along an optical fiber. To achieve this control we use the effect of Stimulated Brillouin Scattering. In our experiments we have achieved changes in the group index of 10^-3 in several kilometer-length fibers, thus leading to pulse delaying and advancement in the range of tens of nanoseconds. We believe that this is the first evidence of such optically-controlled strong delay changes in optical fibers. In this paper we derive the basic theory behind these group-delay changes and we demonstrate the effect in two kinds of fibers which are conventionally used.

So far, the optical pulses used in phase-sensitive OTDR (ΦOTDR) were typically engineered so as to have a constant phase along the pulse. In this work, it is demonstrated that by acting on the phase profile of the optical pulses, it is possible to introduce important conceptual and practical changes to the traditional ΦOTDR operation, thus opening a door for new possibilities which are yet to be explored. Using a ΦOTDR with linearly chirped pulses and direct detection, the distributed measurement of temperature/strain changes from trace to trace, with 1mK/4nε resolution, is theoreticaly and experimentaly demonstrated. The measurand resolution and sensitivity can be tuned by acting on the pulse chirp profile. The technique does not require a frequency sweep, thus greatly decreasing the measurement time and complexity of the system, while maintaining the potential for metric spatial resolutions over tens of kilometers as in conventional ΦOTDR. The technique allows for measurements at kHz rates, while maintaining reliability over several hours.

Brillouin slow light in optical fibers is a promising technique for the development of all-optical buffers to be used in optical routers. The main drawback of this technique up to now has been its narrow bandwidth, normally restricted to 35 MHz in conventional single-mode optical fibers. In this paper we demonstrate experimentally that Brillouin slow light with an arbitrary large bandwidth can be readily obtained in conventional optical fibers using a simple and inexpensive pump spectral broadening technique. In our experiments, we show the delaying of 2.7 ns pulses over slightly more than one pulse length with only some residual broadening (<25%) of the pulse width. We see no limit to extend this technique to the delaying of GHz-bandwidth signals.

Continuous, real-time monitoring of surface seismic activity around the globe is of great interest for acquiring new insight into global tomography analyses and for recognition of seismic patterns leading to potentially hazardous situations. The already-existing telecommunication fiber optic network arises as an ideal solution for this application, owing to its ubiquity and the capacity of optical fibers to perform distributed, highly sensitive monitoring of vibrations at relatively low cost (ultra-high density of point sensors available with minimal deployment of new equipment). This perspective article discusses early approaches on the application of fiber-optic distributed acoustic sensors (DASs) for seismic activity monitoring. The benefits and potential impact of DAS technology in these kinds of applications are here illustrated with new experimental results on teleseism monitoring based on a specific approach: the so-called chirped-pulse DAS. This technology offers promising prospects for the field of seismic tomography due to its appealing properties in terms of simplicity, consistent sensitivity across sensing channels, and robustness. Furthermore, we also report on several signal processing techniques readily applicable to chirped-pulse DAS recordings for extracting relevant seismic information from ambient acoustic noise. The outcome presented here may serve as a foundation for a novel conception for ubiquitous seismic monitoring with minimal investment.

We demonstrate a method to achieve an extremely wide and flexible external control of the group velocity of signals as they propagate along an optical fiber. This control is achieved by means of the gain and loss mechanisms of stimulated Brillouin scattering in the fiber itself. Our experiments show that group velocities below $71000\mathrm{km}∕\mathrm{s}$ on one hand, well exceeding the speed of light in vacuum on the other hand and even negative group velocities can readily be obtained with a simple benchtop experimental setup. We believe that the fact that slow and fast light can be achieved in a standard single-mode fiber, in normal environmental conditions and using off-the-shelf instrumentation, is very promising for a future use in real applications.

This paper presents the first available report in the literature of a system aimed at the detection and classification of threats in the vicinity of a long gas pipeline. The system is based on phase-sensitive optical time-domain reflectometry technology for signal acquisition and pattern recognition strategies for threat identification. The system operates in two different modes: 1) machine+activity identification, which outputs the activity being carried out by a certain machine; and 2) threat detection, aimed at detecting threats no matter what the real activity being conducted is. Different strategies dealing with position selection and normalization methods are presented and evaluated using a rigorous experimental procedure on realistic field data. Experiments are conducted with eight machine+activity pairs, which are further labeled as threat or nonthreat for the second mode of the system. The results obtained are promising given the complexity of the task and open the path to future improvements toward fully functional pipeline threat detection systems operating in real conditions.