Current international guidelines advocate achieving at least a 30 % reduction in maximum plantar pressure to reduce the risk of foot ulcers in people with diabetes. However, whether plantar pressures differ in cases with foot ulcers to controls without ulcers is not clear. The aim of this study was to assess if plantar pressures were higher in patients with active plantar diabetic foot ulcers (cases) compared to patients with diabetes without a foot ulcer history (diabetes controls) and people without diabetes or a foot ulcer history (healthy controls). Twenty-one cases with diabetic foot ulcers, 69 diabetes controls and 56 healthy controls were recruited for this case-control study. Plantar pressures at ten sites on both feet and stance phase duration were measured using a pre-established protocol. Primary outcomes were mean peak plantar pressure, pressure-time integral and stance phase duration. Non-parametric analyses were used with Holm’s correction to correct for multiple testing. Binary logistic regression models were used to adjust outcomes for age, sex and body mass index. Median differences with 95 % confidence intervals and Cohen’s d values (standardised mean difference) were reported for all significant outcomes. The majority of ulcers were located on the plantar surface of the hallux and toes. When adjusted for age, sex and body mass index, the mean peak plantar pressure and pressure-time integral of toes and the mid-foot were significantly higher in cases compared to diabetes and healthy controls (p < 0.05). The stance phase duration was also significantly higher in cases compared to both control groups (p < 0.05). The main limitations of the study were the small number of cases studied and the inability to adjust analyses for multiple factors. This study shows that plantar pressures are higher in cases with active diabetic foot ulcers despite having a longer stance phase duration which would be expected to lower plantar pressure. Whether plantar pressure changes can predict ulcer healing should be the focus of future research. These results highlight the importance of offloading feet during active ulceration in addition to before ulceration.
Foot ulceration is the main precursor to lower limb amputation in patients with type 2 diabetes worldwide. Biomechanical factors have been implicated in the development of foot ulceration; however the association of these factors to ulcer healing remains less clear. It may be hypothesised that abnormalities in temporal spatial parameters (stride to stride measurements), kinematics (joint movements), kinetics (forces on the lower limb) and plantar pressures (pressure placed on the foot during walking) contribute to foot ulcer healing. The primary aim of this study is to establish the biomechanical characteristics (temporal spatial parameters, kinematics, kinetics and plantar pressures) of patients with plantar neuropathic foot ulcers compared to controls without a history of foot ulcers. The secondary aim is to assess the same biomechanical characteristics in patients with foot ulcers and controls over-time to assess whether these characteristics remain the same or change throughout ulcer healing. The design is a case–control study nested in a six-month longitudinal study. Cases will be participants with active plantar neuropathic foot ulcers (DFU group). Controls will consist of patients with type 2 diabetes (DMC group) and healthy participants (HC group) with no history of foot ulceration. Standardised gait and plantar pressure protocols will be used to collect biomechanical data at baseline, three and six months. Descriptive variables and primary and secondary outcome variables will be compared between the three groups at baseline and follow-up. It is anticipated that the findings from this longitudinal study will provide important information regarding the biomechanical characteristic of type 2 diabetes patients with neuropathic foot ulcers. We hypothesise that people with foot ulcers will demonstrate a significantly compromised gait pattern (reduced temporal spatial parameters, kinematics and kinetics) at base line and then throughout the follow-up period compared to controls. The study may provide evidence for the design of gait-retraining, neuro-muscular conditioning and other approaches to off-load the limbs of those with foot ulcers in order to reduce the mechanical loading on the foot during gait and promote ulcer healing.
The purpose of this study was to determine the reliability and validity of plantar pressure and reaction force measured using the Moticon and Pedar-x sensor insoles while rowing on a Concept2 ergometer. Nineteen participants performed four 500 m trials of ergometer rowing at 22–24 strokes/min; two trials wearing Moticon insoles and two wearing Pedar-x insoles in a randomised order. Moticon and Pedar-x insoles both showed moderate to strong test–retest reliability (ICC = 0.57–0.92) for mean and peak plantar pressure and reaction force. Paired t-test demonstrated a significant difference (p < 0.001) between Moticon and Pedar-x insoles, effect size showed a large bias (ES > 1.13), and Pearson’s correlation (r < 0.37) showed poor agreement for all plantar pressure and reaction force variables. Compared to Pedar-x, the Moticon insoles demonstrated poor validity, however, the Moticon insoles had strong reliability. Due to poor validity, caution should be used when considering Moticon insoles to assess changes in pressure and force reliably over time, across multiple trials or sessions. Moticon’s wireless and user-friendly application would be beneficial for assessing and monitoring biomechanical parameters in rowing if validity between measures of interest and Moticon’s results can be established.
Natural gestures are crucial for mid-air interaction, but predicting and managing muscle fatigue is challenging. Existing torque-based models are limited in their ability to model above-shoulder interactions and to account for fatigue recovery. We introduce a new hybrid model, NICER , which combines a torque-based approach with a new term derived from the empirical measurement of muscle contraction and a recovery factor to account for decreasing fatigue during rest. We evaluated NICER in a mid-air selection task using two interaction methods with different degrees of perceived fatigue. Results show that NICER can accurately model above-shoulder interactions as well as reflect fatigue recovery during rest periods. Moreover, both interaction methods show a stronger correlation with subjective fatigue measurement ( ρ = 0.978/0.976) than a previous model, Cumulative Fatigue ( ρ = 0.966/0.923), confirming that NICER is a powerful analytical tool to predict fatigue across a variety of gesture-based interactive applications.
Pre-match warm-ups are standard in many sports but the focus has excluded the substitute players. The aim of this research was to investigate the result of inactivity on physiological and performance responses in substitute basketball players during competition. Two basketball players from the second tier of the State League of Queensland, Australia volunteered for this study and were assessed for performance (countermovement jump—CMJ) and physiological (core temperature via ingestible pill; skin temperature at the arm, chest, calf and thigh; heart rate—HR) responses prior to and following a 20-min warm-up, and during the first half of a competitive basketball match (2 × 20-min real time quarters). Warm up resulted in increases in CMJ (~7%), HR (~100 bpm) and core (~0.8 °C) and skin (~1.0 °C) temperatures. Following the warm up and during inactivity, substitute players exhibited a decrease in all responses including CMJ (~13%), HR (~100 bpm), and core (~0.5 °C) and skin (~2.0 °C) temperatures. Rest resulted in reductions in key performance and physiological responses during a competitive match that poses a risk for match strategies. Coaches should consider implementing a warm up to enhance core/skin temperature for substitute players immediately before they engage with competition to optimise player performance.
29 January 2016 in Journal of Foot and Ankle Research
Background: Several prospective studies have suggested that gait and plantar pressure abnormalities secondary to diabetic peripheral neuropathy contributes to foot ulceration. There are many different methods by which gait and plantar pressures are assessed and currently there is no agreed standardised approach. This study aimed to describe the methods and reproducibility of three‐dimensional gait and plantar pressure assessments in a small subset of participants using pre‐existing protocols.Methods: Fourteen participants were conveniently sampled prior to a planned longitudinal study; four patients with diabetes and plantar foot ulcers, five patients with diabetes but no foot ulcers and five healthy controls. The repeatability of measuring key biomechanical data was assessed including the identification of 16 key anatomical landmarks, the measurement of seven leg dimensions, the processing of 22 three‐dimensional gait parameters and the analysis of four different plantar pressures measures at 20 foot regions.Results: The mean inter‐observer differences were within the pre‐defined acceptable level ( 0.9 for 100 % (7 of 7) of leg dimensions. The coefficients of variations (CVs) were within the pre‐defined acceptable level (<10 %) for 100 % (22 of 22) of gait parameters. The CVs were within the pre‐defined acceptable level (<30 %) for 95 % (19 of 20) of the contact area measures, 85 % (17 of 20) of mean plantar pressures, 70 % (14 of 20) of pressure time integrals and 55 % (11 of 20) of maximum sensor plantar pressure measures.Conclusion: Overall, the findings of this study suggest that important gait and plantar pressure measurements can be reliably acquired. Nearly all measures contributing to three‐dimensional gait parameter assessments were within predefined acceptable limits. Most plantar pressure measurements were also within predefined acceptable limits; however, reproducibility was not as good for assessment of the maximum sensor pressure. To our knowledge, this is the first study to investigate the reproducibility of several biomechanical methods in a heterogeneous cohort.