This work investigated the effectiveness of zerovalent iron and Fe/Ni bimetallic nanoparticles in the treatment of water polluted by a high concentration of nitrates. Nanoparticle synthesis was carried out by a sodium borohydride reduction method in the presence of sodium oleate as a surfactant. The particles were characterized by XRD and SEM. Batch experiments were conducted on water samples contaminated by 300 mg L−1 of nitrate. The parameters investigated were the Fe/Ni dosage (0.05, 0.1, 0.2, 0.3, and 0.4 g L−1) and the reaction pH (unbuffered; buffered at pH = 3; initial pH = 3, 5, and 10). The results showed that almost complete nitrate removal (>99.8%) was always achieved after 15 min at a concentration of bimetallic nanoparticles higher than 0.2 g L−1. The optimization of bimetallic nanoparticle dosage was carried out at a fixed pH. Kinetic study tests were then performed at different temperatures to assess the effect of temperature on the nitrate removal rate. By fixing the pH at acidic values and with an operating temperature of 303 K, nitrates were completely removed after 1 min of treatment.
The structure and dielectric measurements made on the nanocomposites based on PP polypropylen and TiO2 nanoparticles are reported in this paper. It has been defined that, the incorporation of TiO2 nanoparticles to the PP matrix enhances the dielectric constant of nanocomposites in comparison with the pristine polypropylene. The dependence of dielectric permittivity of nanocomposites of different volume contents of titanium dioxide (TiO2) nanoparticles changes with an extremum, for 1% content of TiO2 nanoparticles in polypropylene matrix the dielectric permittivity (er') reaches at its peak and then gradually decreaseMoreover the posistor effect is observed for nanocomposites based on PP/TiO2. Thermal properties of PP/TiO2 nanocomposites were also studied. With the addition of nanoparticles with the volume content of 1% the degradation temperature for nanocomposites shifts to relatively higher temperatures (54 °C) as compared to the pure polymer. At lower concentrations, nanoparticles play the role of structurant, which in turn leads to the enhancement of electrophysical and thermal properties of these nanocomposites.
27 December 2017 in Polymer-Plastics Technology and Engineering
In this study, we report about the preparation of magnetic polymer nanocomposites on the basis of isotactic polypropylene and magnetite Fe3O4 nanoparticles. The structure and composition of polymer nanocomposite materials have been studied by scanning electron microscopy, atomic force microscopy, and X-ray dispersive analysis. The magnetic properties of polymer nanocomposites based on PP+Fe3O4have been investigated. It is found that not significant adhesion and agglomeration of nanoparticles occur, by increasing the nanoparticle content in polymer matrix up to 40%, and therefore they act as single-domain nanoparticles. The samples of nanocomposites based on PP+Fe3O4, with up to 40% content of Fe3O4, exhibit superparamagnetic properties. It was also found out that the magnetic polymer nanocomposite material based on PP+Fe3O4 is able to absorb ultrahigh frequency electromagnetic waves in the frequencies range from 0.1 to 30 GHz. The increase in Fe3O4 concentration from 5 to 40% at the 400 µm thicknesses of the films leads to an increase in absorption of electromagnetic waves of high frequency from 15 to 22.7%. GRAPHICAL ABSTRACT
In the present study, the effect of size distribution of magnetite nanoparticles in a PVDF matrix on the magnetic properties of PVDF + Fe3O4 nanocomposites was experimentally and theoretically investigated. The size distribution of nanoparticles in polymer matrix and morphology of the nanocomposites were studied by the means of scanning electron microscopy and atomic force microscopy. It was found that when the Fe3O4 nanoparticles are introduced into the polymer matrix, their coagulation takes place. The increase in the size of the particles depends on their concentration in the polymer matrix, the type of polymer (polar, non-polar, its viscosity, etc.), reaction temperatures, etc. In addition, when Fe3O4 nanoparticles are introduced into the polymer network, the oxidation of the surface layer of particles occurs and the magnetic size decreases. Consequently, the reduced magnetic properties may also be observed. The hysteresis loops have been recorded in small magnetic field range. It was found that the magnetic hysteresis parameters depend on the size and concentration of Fe3O4 nanoparticles. Theoretical calculations were compared with experimental results obtained from M(H) measurements. The reasons of differences between theoretical and experimental results have been explained.