Concrete barriers prevent vehicles from entering the opposite lane and going off the road. An important factor in the design of concrete barriers is impact load, which a vehicle exerts upon collision with a concrete barrier. This study suggests that a height of 813 mm, a base width of 600 mm, and a top width of 240 mm are optimum dimensions for a concrete barrier. These dimensions ensure the stability of concrete barriers during vehicle collisions. An analytical and experimental model is used to analyze the concrete barrier design. The LS-DYNA software is utilized to create the analytical models because it can effectively simulate vehicle impact on concrete barriers. Field tests are conducted with a vehicle, whereas laboratory tests are conducted with machines that simulate collisions. Full-scale tests allow the actual simulation of vehicle collisions with concrete barriers. In the vehicle tests, a collision angle of 25°, collision speeds of 100 km per hour, and a vehicle weighing more than 2 t are considered in the reviewed studies. Laboratory tests are performed to test bridge concrete barriers in static condition.
10 September 2020 in Journal of Building Engineering
This paper presents a new portable concrete barrier (NPCB) design that can be placed in areas where vehicles may not enter. The proposed design is fabricated with a new shape, composed of three parts, and equipped with an interlocking connection between adjacent concrete barriers. LS-DYNA computer simulation was performed to assess whether the NPCB is in accordance with the roadside design criteria. The results showed that the new model can effectively contain and redirect collided vehicles as well as lessen the damage of vehicles. The results demonstrated little lateral deflection, which can facilitate an easy bonding between the NPCB and the floor. The occupant compartment did not penetrate, thereby keeping the driver and tenants safe during an accident. Comparison of the NPCB simulation, theoretical and the full-scale test results revealed that the simulation model is accurate and is well within the specification requirements.
1 December 2013 in Iraqi Journal of Civil Engineering
This research paper is accomplished to study the effect of using waste fibers in properties of concrete . Steel lathe waste fibers are added by percentages of (4, 6 and 8 %) from weight of concrete and a percentages of concrete coarse aggregate are replaced by rubber tires waste fibers in a ratios of (5, 10 and 15%) by volume . Besides to that, the combined fibers are used steel lathe waste fibers by adding (4, 6 and 8 %) with constant replacing of rubber tires waste fibers of (10 %). The results showed that adding of steel lathe waste fibers in plain concrete enhances its strength under compression about (15%) and tension about (20%), while rubber tires waste reduced both of compression about (80 %) and tension about (51%) strengths .Also the compression and tension strengths are reduced (88% and 30%) respectively with using combined fibers . The dry concrete density of lathe waste fibers concrete is (2345-2365kN/m3) , the rubberized concrete density is (2130-2240kN/m3) and for combined fibers concrete density (2025-2180 kN/m3).
13 September 2023 in Innovative Infrastructure Solutions