Pesticide contamination of bee products is a widespread phenomenon. Due to its composition, bee bread is affected by both lipophilic and hydrophilic substances. As proof of concept of a monitoring campaign and to better understand the extent of contamination, we developed an analytical method based on a modified QuEChERS extraction, with subsequent separation by liquid chromatography and detection by mass spectrometry. This allowed for the quantitation of 51 agricultural- or beekeeping-associated pesticides in bee bread. The workflow was applied to 60 samples taken biweekly throughout spring to autumn 2022 from five colonies at a Swiss apiary in an agricultural area. In total, 30 pesticides were identified (> LOD), among which 26 pesticides were quantitated. The total number of pesticides detected per colony ranged from 11 to 19. The most prevalent substances (> LOQ) were two neonicotinoid insecticides, acetamiprid and thiacloprid (max. 16 μg/kg and 37 μg/kg, respectively); seven fungicides, azoxystrobin (max. 72 μg/kg), boscalid (max. 50 μg/kg), cyprodinil (max. 1965 μg/kg), difenoconazole (max. 73 μg/kg), mandipropamid (max. 33 μg/kg), pyraclostrobin (max. 8 μg/kg) and trifloxystrobin (max. 38 μg/kg); and two herbicides, prosulfocarb (max. 38 μg/kg) and terbuthylazine (max. 26 μg/kg). The study revealed strong variability in pesticide occurrence and concentrations among colonies sampled at the same site and date. The applied biweekly sampling of bee bread from March to August was shown to be reliable in capturing peak contaminations and revealing the onset of certain pesticides in bee bread. The study provides an adequate practical approach for pesticide monitoring campaigns.
The importance of the stable isotopes in tree rings for the study of the climate variations caused by volcanic eruptions is still unclear. We studied δ18O, δD, δ13C stable isotopes of larch and cembran pine cellulose around four major eruptions with annual resolution, along with a superposed epoch analysis of 34 eruptions with 5-year resolution. Initial analysis of the tropical Tambora (1815 CE) and Samalas (1257 CE) eruptions showed a post-eruption decrease in δ18O values attributed to post-volcanic cooling and increased summer precipitation in Southern Europe, as documented by observations and climate simulations. The post-volcanic cooling was captured by the δD of speleothem fluid inclusion. The δ18O decrease was also observed in the analysis of 34 major tropical eruptions over the last 2000 years. In contrast, the eruptions of c. 750, 756, and 764 CE attributed to Icelandic volcanoes left no significant responses in the cellulose isotopes. Further analysis of all major Icelandic eruptions in the last 2000 years showed no consistent isotopic fingerprints, with the exception of lower post-volcanic δ13C values in larch. In summary, the δ18O values of cellulose can provide relevant information on climatic and hydroclimatic variations following major tropical volcanic eruptions, even when using the 5-year resolution wood samples of the Alpine Tree-Ring Isotope Record database.
21 March 2026 in Environmental Toxicology and Chemistry
Passive sampling offers a promising approach for assessing contaminants in surface waters; however, its broader adoption is limited by the need for standardized and user-friendly implementation methods and the availability of suitable sorbents. This study investigates the performance of the widely used Empore™ SDB-RPS disk and two potential alternative sorbent phases—Affinisep AttractSPE® HLB (AHLB) and Biotage Atlantic® HLB-L (BHLB)—for the uptake of >100 pesticides with diverse physicochemical properties (logKOW = −2 to 5, pKa = −3.15 to 12.58) and compares them against the Empore SDB-RPS disk. The passive sampler (PS) performance was evaluated under controlled laboratory settings using a flow system at environmentally relevant conditions (21 cm/s, 300 ng/L, 2-week exposure) and an established open-source stainless-steel housing. Diffusive transport characteristics were assessed by determining relative resistances of the water boundary layer and the sorbent to the mass transfer, with average sorbent resistance (1/Rs, tot) contributions ranging from 39% and 40% (AHLB and SDB-RPS) to 87% (BHLB). Performance under field conditions was assessed through a 2-week calibration alongside active sampling in an agricultural stream (22–40 cm/s). Pesticide accumulation was linear to curvilinear (monotonically increasing) for all PSs, despite uptake being partially (AHLB and SDB-RPS) or almost completely (BHLB) controlled by the sorbent. The uptake of pesticides to all PSs could be well described by a simple first-order uptake model as opposed to more complex approaches, such as incorporating fluctuating water concentrations or diffusion models. Laboratory sampling rates (Rs) could be determined for 78% of pesticides. Comparable results were observed for AHLB (Rs average = 0.42 ± 0.24 L/day) and SDB-RPS (Rs average = 0.41 ± 0.27 L/day), whereas BHLB showed lower rates (on average, a factor of 5 lower). Field evaluations confirmed the similar capabilities of AHLB to SDB-RPS, detecting ≥43 of the studied pesticides, while BHLB detected fewer (29 pesticides), likely due to its fiberglass structure acting as additional resistance. For all sorbents and compounds with available sampling rates (>50% of detected compounds in the field), time-weighted average concentrations derived from PS closely matched active sampling measurements between 0.5 and 2.5 times, supporting their reliability for pesticide quantification. Overall, this study provides recoveries, sampling rates, and sampler–water partition coefficients (Ksw) for three PSs for a range of pesticides. This work helps to facilitate the broader adoption of passive sampling techniques for regulatory and environmental analysis.