This paper proposes a new capacitive coupling wireless power transfer method for charging electric vehicles. Capacitive coupling wireless power transfer can replace conventional inductive coupling wireless power transfer because it has negligible eddy-current loss, relatively low cost and weight, and good misalignment performance. However, capacitive coupling wireless power transfer has a limitation in charging electric vehicles due to too small coupling capacitance via air with a very high frequency operation. The new capacitive wireless power transfer uses glass as a dielectric layer in a vehicle. The area and dielectric permittivity of a vehicle’s glass is large; hence, a high capacity coupling capacitor can be obtained. In addition, switching losses of a power conversion circuit are reduced by quasi-LLC resonant operation with two transformers. As a result, the proposed system can transfer large power and has high efficiency. A 1.6 kW prototype was designed to verify the operation and features of the proposed system, and it has a high efficiency of 96%.
In the present scenario of the fossil fuel crisis, a shift from conventional transportation to electric vehicles (EVs) is the goal, and it is necessary to make it economically feasible. Developing an efficient charger with mid-range power level may successfully resolve this problem. In this direction, an EV charging infrastructure has been proposed to achieve grid-to-vehicle (G2V) charging, with vehicle-to-grid (V2G) capability. In G2V mode, the proposed infrastructure consists of an on-board, single-phase, 7.7 kW totem pole converter in continuous conduction mode to achieve high-power factor correction (PFC). Additionally, instead of conventional Si power MOSFET, an SiC-based converter is introduced to lower the switching losses at high switching frequency with smaller filters. Using an SiC-based converter leads to increased efficiency (more than 98%) and reduced total harmonic distortion (less than 5%), making the system economical. Simultaneously, to make the system more economical, the proposed converter works as an inverter to feedback the power to the grid in V2G mode. Furthermore, to analyse the feasibility, the proposed infrastructure has been simulated and its performance is validated using the simpower tool in MATLAB/Simulink environment.
This paper analyzes the output voltage of an inductive wireless power transfer (WPT) depending on coupling conditions. When the optimum efficiency and maximum output power are obtained, it is called critical coupling, so the receiving coil and the transmitting coil should be separated by a certain distance. When the distance between the transmitting coil and receiving coil is very short, it is called over coupling, and output power decreases with the optimal operating state of the critical coupling condition. To design the entire circuit system for the inductive WPT depending on the coupling condition, it is beneficial to analyze the output voltage according to a load variation, an input voltage, and an operating frequency. Therefore, the output voltage depending on the coupling condition in the inductive WPT is analyzed in this paper. The output voltage gain in critical coupling condition is greater than one and is not affected by a load variation by a series LC resonant operation. The reduced output power in an over coupling condition can be recovered by a series LLC resonant operation. In addition, the output voltage gain is almost one and is affected by the load variation in the over coupling condition. A 5W prototype is implemented with the wireless power consortium standard coils and experimental results are shown to verify theoretical analysis and operation.
In this paper, a new LLC converter for series-connected, high-voltage LEDs is proposed. The proposed LLC converter consists of two stacked, single-ended rectifiers and one balancing capacitor, to compensate for the current deviation of two individual LED strings. The proposed LLC LED driver can use a diode with low voltage stress, even if the secondary LED is connected in series to have a high driving voltage. In addition, even if several series-connected LEDs are changed into two-stacked structures, the balancing capacitor can compensate for the current deviation of the two separated LEDs, as well as the difference in leakage inductance of the two stacked single-ended rectifiers. The balancing capacitor can be made equal to the voltage tolerance of the stacked, single-ended rectifier diodes. The proposed circuit can be easily extended to a series channel LED driver circuit, without increasing the voltage stress. To verify the characteristics and operation of the proposed LLC LED driver, a 260W high-power LED driver is implemented.