Ingo Roland Titze

Prof. Ingo Roland Titze

University of Utah, Salt Lake City, Utah, USA
orcid

Research Focus & Metrics

Academic Career Length

43Years (1984-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2015 in Journal of Speech, Language, and Hearing Research
Verified
Journal Article
Closed access
ITIngo Roland Titze
Ingo Roland Titze
EHEric J Hunter
Eric J Hunter
Purpose: Schoolteachers have become a benchmark population for the study of occupational voice use. A decade of vibration-dose studies on the teacher population allows a comparison to be made between specific dose measures for eventual assessment of damage risk. Method: Vibration dosimetry is reformulated with the inclusion of collision stress. Two methods of estimating amplitude of vocal-fold vibration are compared to capture variations in vocal intensity. Energy loss from collision is added to the energy-dissipation dose. An equal-energy-dissipation criterion is defined and used on the teacher corpus as a potential-damage risk criterion. Results: Comparison of time-, cycle-, distance-, and energy-dose calculations for 57 teachers reveals a progression in information content in the ability to capture variations in duration, speaking pitch, and vocal intensity. The energy-dissipation dose carries the greatest promise in capturing excessive tissue stress and collision but also the greatest liability, due to uncertainty in parameters. Cycle dose is least correlated with the other doses. Conclusion: As a first guide to damage risk in excessive voice use, the equal-energy-dissipation dose criterion can be used to structure trade-off relations between loudness, adduction, and duration of speech.

1 August 2009 in Journal of Speech, Language, and Hearing Research
Verified
Journal Article
Closed access
ITIngo Roland Titze
Ingo Roland Titze
Purpose: The purpose of this article was to determine if a semi-occluded vocal tract could be used to measure phonation threshold pressure. This is in contrast to the shutter technique, where an alternation between a fully occluded tract and an unoccluded tract is used. Method: Five male and 5 female volunteers phonated through a thin straw held between the lips. Oral pressure behind the lips was measured. Mathematical predictions of phonation threshold pressures were compared to the measured ones over a range of frequencies. Results: It was shown that, for a 2.5-mm diameter straw, phonation threshold pressures were obtainable over a 2-octave range of fundamental frequency by all volunteers. In magnitude, the pressures agreed with the 0.2–0.5 kPa values obtained in previous investigations. Sensitivity to viscoelastic and geometric properties of the vocal folds was generally not compromised with greater oral impedance, but some differences were predicted theoretically in contrast to an open mouth configuration. Conclusion: Because phonation threshold pressure is always dependent on vocal tract interaction, it may be advantageous to choose an exact and fixed oral semi-occlusion for the measurement and interpret the results in light of the known acoustic load.

15 November 2010 in Journal of Experimental Biology
Verified
Journal Article
Closed access
PDF file
ITIngo Roland Titze
Ingo Roland Titze
WFW. Tecumseh Fitch
W. Tecumseh Fitch
EHEric J Hunter
Eric J Hunter
FAFariborz Alipour
Fariborz Alipour
DMDouglas Montequin
Douglas Montequin
EWEdward J. Walsh
Edward J. Walsh
SUMMARY Despite the functional importance of loud, low-pitched vocalizations in big cats of the genus Panthera, little is known about the physics and physiology of the mechanisms producing such calls. We investigated laryngeal sound production in the laboratory using an excised-larynx setup combined with sound-level measurements and pressure–flow instrumentation. The larynges of five tigers (three Siberian or Amur, one generic non-pedigreed tiger with Bengal ancestry and one Sumatran), which had died of natural causes, were provided by Omaha's Henry Doorly Zoo over a five-year period. Anatomical investigation indicated the presence of both a rigid cartilaginous plate in the arytenoid portion of the glottis, and a vocal fold fused with a ventricular fold. Both of these features have been confusingly termed ‘vocal pads’ in the previous literature. We successfully induced phonation in all of these larynges. Our results showed that aerodynamic power in the glottis was of the order of 1.0 W for all specimens, acoustic power radiated (without a vocal tract) was of the order of 0.1 mW, and fundamental frequency ranged between 20 and 100 Hz when a lung pressure in the range of 0–2.0 kPa was applied. The mean glottal airflow increased to the order of 1.0 l s–1 per 1.0 kPa of pressure, which is predictable from scaling human and canine larynges by glottal length and vibrational amplitude. Phonation threshold pressure was remarkably low, on the order of 0.3 kPa, which is lower than for human and canine larynges phonated without a vocal tract. Our results indicate that a vocal fold length approximately three times greater than that of humans is predictive of the low fundamental frequency, and the extraordinarily flat and broad medial surface of the vocal folds is predictive of the low phonation threshold pressure.

1 May 2017 in Journal of Voice
Verified
Journal Article
Closed access
ITIngo Roland Titze
Ingo Roland Titze
LMLynn M. Maxfield
Lynn M. Maxfield
MWMegan C. Walker
Megan C. Walker

22 April 2014 in IEEE Transactions on Biomedical Engineering
Verified
Journal Article
Closed access
APAnil Kumar Palaparthi
Anil Kumar Palaparthi
TRTobias Riede
Tobias Riede
ITIngo Roland Titze
Ingo Roland Titze
Morphological design and the relationship between form and function have great influence on the functionality of a biological organ. However, the simultaneous investigation of morphological diversity and function is difficult in complex natural systems. We have developed a multiobjective optimization (MOO) approach in association with cluster analysis to study the form-function relation in vocal folds. An evolutionary algorithm (NSGA-II) was used to integrate MOO with an existing finite element model of the laryngeal sound source. Vocal fold morphology parameters served as decision variables and acoustic requirements (fundamental frequency, sound pressure level) as objective functions. A two-layer and a three-layer vocal fold configuration were explored to produce the targeted acoustic requirements. The mutation and crossover parameters of the NSGA-II algorithm were chosen to maximize a hypervolume indicator. The results were expressed using cluster analysis and were validated against a brute force method. Results from the MOO and the brute force approaches were comparable. The MOO approach demonstrated greater resolution in the exploration of the morphological space. In association with cluster analysis, MOO can efficiently explore vocal fold functional morphology.

29 March 2021 in PLOS Computational Biology
Verified
Journal Article
Open access
PDF file
ITIngo Roland Titze
Ingo Roland Titze
APAnil Kumar Palaparthi
Anil Kumar Palaparthi
KCKarin Cox
Karin Cox
ASAmanda Stark
Amanda Stark
LMLynn Maxfield
Lynn Maxfield
BMBrian Manternach
Brian Manternach
Vocalization in mammals, birds, reptiles, and amphibians occurs with airways that have wide openings to free-space for efficient sound radiation, but sound is also produced with occluded or semi-occluded airways that have small openings to free-space. It is hypothesized that pressures produced inside the airway with semi-occluded vocalizations have an overall widening effect on the airway. This overall widening then provides more opportunity to produce wide-narrow contrasts along the airway for variation in sound quality and loudness. For human vocalization described here, special emphasis is placed on the epilaryngeal airway, which can be adjusted for optimal aerodynamic power transfer and for optimal acoustic source-airway interaction. The methodology is three-fold, (1) geometric measurement of airway dimensions from CT scans, (2) aerodynamic and acoustic impedance calculation of the airways, and (3) simulation of acoustic signals with a self-oscillating computational model of the sound source and wave propagation.