International audienceThe article presents findings of a study on CO2/CH4 exchange sorption taking place in a coal briquette, initiated by the injection of a CO2 into a briquette that was previously saturated with CH4. The briquette was subjected to multiple cycles consisting of vacuum outgassing, CH4 saturation under 10 bar pressure, and an exchange sorption process. In each experiment input CO2 pressure and output gas mixture pressure were stabilized. The chosen pressure levels were 12, 13 and 11 bar at the input and 10 bar at the output of the briquette. Flow rate of gas streams flowing to and flowing out of the briquette, as well as gas concentration at the output of the briquette, was measured. During the process of exchange sorption, the flow rate of gas streams at the input and output of the briquette varied, even though the input and output pressures were constant. In all the experiments, the entire CH4 was displaced from the briquette after injecting about twice the rate of the CO2 mass in relation to the previously sorptive bonded CH4. The results thus obtained were confronted with results obtained by other researchers, available in relevant sources, for the purpose of their comparison

Among the numerous factors that have an impact on coal permeability, coal porosity is one of the main parameters. A change in the mechanical stress applied to coal results in a change of porosity. The main objective of the conducted research was to answer the following question: is a decline in coal permeability a direct effect of a decrease in coal porosity, and does mechanical stress result solely in a porosity change? A study of coal porosity under mechanical stress conditions was conducted using a uniquely constructed measurement stand. The coal samples used were briquettes prepared from a granular coal material (middle-rank coal of type B—meta bituminous, upper carboniferous formation) from the “Zofiówka” coal mine, in Poland. In order to describe coal permeability, the Klinkenberg equation was used, as it takes into consideration the slippage effect, typical of porous media characterized by low permeability. On the basis of the obtained results, it was established that the values of the Klinkenberg permeability coefficient decrease as the mechanical stress and the corresponding reduction in porosity become greater. As the briquette porosity increased, the Klinkenberg slippage effect: (i) disappeared in the case of nitrogen, (ii) and was minor for methane. The briquettes used were characterized by various porosities and showed that mechanical stress results mainly in a change in coal porosity, which, in turn, reduces coal permeability.

Basic knowledge of the characteristics of copper-bearing rock such as dolomite is essential to locate those areas of the deposit which have different structural and textural properties. Those regions can be important in terms of the assessment of the possibilities of gas accumulating in them as well as in terms of gasogeodynamic hazard. To better understand those threats, it is necessary to locate, monitor and analyse those areas in detail. This article characterises the structural and textural parameters of dolomite from the Polkowice–Sieroszowice copper mine in Poland. The study involved five samples from various areas of the mine. A number of research methods were selected. Reflected and transmitted light microscopy (MS), computer microtomography (Micro-CT), gas adsorption porosimetry (LPNA), mercury porosimetry (MIP), helium and quasi-fluid pycnometry (Pycno. He, DryFlo). Each of the methods examined a different scope of the pore size, which enabled to achieve a full view of the porous nature of those rocks. We determined their porosity (open, closed, total), surface area as well as mean size and volume of the pores. Also, we studied the character and the pore size distribution from a few nm to a few mm. Comprehensive dolomite properties analyses showed that these rocks are characterised by high structural variability. They have mesopores and macropores but few micropores. The analyses presented in this paper are determined by a large petrographic diversity of the deposits containing dolomite. This article is an example of a comprehensive approach to the rock analysis in copper ore mines.