The ice generation is one of the challenges facing the methane hydrate depressurization, which, however, has not been fully addressed by existing numerical models for hydrate-bearing sediments (HBS). In this study, we develop a high-fidelity, fully coupled thermo-hydro-mechanical-chemical numerical model that incorporates the effect of ice. The model, developed using COMSOL, takes into account water–ice phase change, thermally induced cryogenic suction and constitutive relation in HBS. It is verified well against the temperature, pressure and cumulative gas production of Masuda’s experiment. The model is then employed to investigate multiphysical responses and gas/water production when ice generation is induced by setting a low outlet pressure. The results reveal that ice forms near the outlet boundary of the specimen center, leading to a reduction in intrinsic permeability and fluid velocity and an increase in the bulk modulus of ice-HBS. This enhanced bulk modulus results in higher porosity under axial load. Although the exothermic effect of ice generation promotes the hydrate dissociation, the effect on cumulative gas production is negligible after the ice melts. A negative correlation between ice saturation and water production rate is observed, indicating that a higher gas–water ratio can be achieved by adjusting the ice duration during hydrate production. The developed coupled model proves to be crucial for understanding the effect of ice on hydrate exploitation.
SUMMARY: Latent heat of soil water phase transition is an important parameter affecting the prediction of the temperature field in a frozen soil. With the nonlinear change of unfrozen water content in freezing soil, the latent heat appears nonlinearly in a frozen soil. To evaluate the influence of the estimation of phase quantity and phase change interval on the formation of the temperature field in a frozen soil, the thermal parameters at different temperatures are measured, and a soil freezing model test is carried out. Meanwhile, based on the evolutionary trend of the unfrozen water content, a precise method of transforming the latent heat of phase change into specific heat and a segment processing method of latent heat in a frozen soil are proposed. Also, these methods are used in the ABAQUS to simulate the temperature of the soil freezing model. The sensitivity of the estimation of phase quantity and phase change interval on the formation of the temperature field in a frozen soil is analysed based on the numerical calculation values and model test values. The results show that the estimation accuracy of phase change interval greatly affects the prediction accuracy of the temperature field in the warm temperature stage, and the method of transforming latent heat into apparent specific heat can improve the prediction accuracy of the temperature field.
1 April 2007 in Frontiers of Mechanical Engineering in China