Heavy oil and biomass co-gasification has been analyzed through a model developed in Aspen Plus™ v 11.0 software. The model was used to assess main gasification parameters, such as cold gas efficiency, yield, low heating value (LHV), and producer gas composition, using air and oxygen as gasification agents. Subsequently, producer gas energy use in the Rankine cycle was performed using a model developed in GateCycle™ v11.1.2.4.850 software. Likewise, the economic indicators of the integrated Rankine cycle-gasification system were calculated. The economic evaluation was developed through Monte Carlo simulation using Crystalball™. The results showed a LHV producer gas decreasing trend as the equivalence ratio (ER) increased, oscillating between 6.37 and 3.63 MJ/Nm3 for ER values greater than 0.30 in the air co-gasification case, while the scenario that used oxygen presented better LHV results, ranging from 9.40 to 11.79 MJ/Nm3. For air co-gasification, the Rankine cycle efficiency range was between 13.0% and 9.5%, while for oxygen co-gasification, values between 14.0% and 13.2% were obtained. Regarding the economic assessment, the two scenarios evaluated (with a reliability of 95%) have a probability higher than 92.1% of economic losses due mainly to the lower electrical power and the local electricity rate.
1 April 2020 in Flow Measurement and Instrumentation
Minas Gerais is Brazil’s largest charcoal producer, relying on carbonization kilns that release effluent gases and waste energy while generating environmental impacts. This work evaluates the electricity generation potential from these gases using different conversion technologies. A database-based assessment of charcoal production units, based on official institutional records, enabled estimating the energy potential for 2020 and projecting it to 2030. Three technologies were assessed: Steam Rankine Cycle, Organic Rankine Cycle, and Externally Fired Gas Turbine. For each one, efficiencies were calculated and applied to the surveyed producers, ranging from 5% to 24% for power capacities between 100 kW and 2000 kW. The highest energy generation potential, 1348 GWh/year, was obtained using the regenerative and superheated ORC with n-decane as the working fluid. In addition, an economic analysis was performed based on Brazilian electricity auction prices, together with a sensitivity analysis of key variables, including installed power, electricity price, minimum attractiveness rate, taxes, operating hours, and capital expenditure. The results demonstrate that current technical and economic conditions are unfavorable for implementing waste-heat-based power plants in Minas Gerais. Plants below 10 MW are especially unfeasible. A Life Cycle Assessment estimated emissions of 2437.7 kg CO2eq per ton of charcoal. Sustainable measures such as eliminating native wood use, increasing Gravimetric Yield, and adding afterburners could reduce emissions by over 57%.