Agricultural development, extensive industrialization, and rapid growth of the global population have inadvertently been accompanied by environmental pollution. Water pollution is exacerbated by the decreasing ability of traditional treatment methods to comply with tightening environmental standards. This review provides a comprehensive description of the principles and applications of electrochemical methods for water purification, ion separations, and energy conversion. Electrochemical methods have attractive features such as compact size, chemical selectivity, broad applicability, and reduced generation of secondary waste. Perhaps the greatest advantage of electrochemical methods, however, is that they remove contaminants directly from the water, while other technologies extract the water from the contaminants, which enables efficient removal of trace pollutants. The review begins with an overview of conventional electrochemical methods, which drive chemical or physical transformations via Faradaic reactions at electrodes, and proceeds to a detailed examination of the two primary mechanisms by which contaminants are separated in nondestructive electrochemical processes, namely electrokinetics and electrosorption. In these sections, special attention is given to emerging methods, such as shock electrodialysis and Faradaic electrosorption. Given the importance of generating clean, renewable energy, which may sometimes be combined with water purification, the review also discusses inverse methods of electrochemical energy conversion based on reverse electrosorption, electrowetting, and electrokinetic phenomena. The review concludes with a discussion of technology comparisons, remaining challenges, and potential innovations for the field such as process intensification and technoeconomic optimization.

Capacitive desalination (CD) is a promising desalination technique as, relative to reverse osmosis (RO), it requires no membrane components, can operate at low (sub-osmotic) pressures, and can potentially utilize less energy for brackish water desalination. In a typical CD cell, the feed water flows through the separator layer between two electrically charged, nanoporous carbon electrodes. This architecture results in significant performance limitations, including an inability to easily (in a single charge) desalinate moderate brackish water feeds and slow, diffusion-limited desalination. We here describe an alternative architecture, where the feed flows directly through electrodes along the primary electric field direction, which we term flow-through electrode (FTE) capacitive desalination. Using macroscopic porous electrode theory, we show that FTE CD enables significant reductions in desalination time and can desalinate higher salinity feeds per charge. We then demonstrate these benefits using a custom-built FTE CD cell containing novel hierarchical carbon aerogel monoliths as an electrode material. The pore structure of our electrodes includes both micron-scale and sub-10 nm pores, allowing our electrodes to exhibit both low flow resistance and very high specific capacitance (>100 F g⁻¹). Our cell demonstrates feed concentration reductions of up to 70 mM NaCl per charge and a mean sorption rate of nearly 1 mg NaCl per g aerogel per min, 4 to 10 times higher than that demonstrated by the typical CD cell architecture. We also show that, as predicted by our model, our cell desalinates the feed at the cell's RC timescale rather than the significantly longer diffusive timescale characteristic of typical CD cells.

Significance: Rapid, early-stage screening is crucial during pandemics for early identification of infected patients and control of disease spread. CRISPR biology offers new methods for rapid and accurate pathogen detection. Despite their versatility and specificity, existing CRISPR diagnostic methods suffer from the requirements of up-front nucleic acid extraction, large reagent volumes, and several manual steps—factors which prolong the process and impede use in low-resource settings. We here combine microfluidics, on-chip electric field control, and CRISPR to directly address limitations of current CRISPR diagnostic methods. We apply our method to the rapid detection of SARS-CoV-2 RNA in clinical samples. Our method takes about 35 min from raw sample to result, a significant improvement over existing nucleic acid-based diagnostic methods for COVID-19.

In this tutorial review aimed at researchers using nanofluidic devices, we summarize the current state of theoretical and experimental approaches to describing concentration polarization (CP) in hybrid microfluidic–nanofluidic systems. We also analyze experimental results for these systems and place them in the context of recent theoretical developments. We then extend the theory to explain the behavior of both positively and negatively charged, low-concentration, analyte species in systems with CP. We conclude by discussing several applications of CP in microfluidics.