Dynamic laser speckle phenomenon allows a contactless and nondestructive way to monitor biological changes that are quantified by second-order statistics applied in the images in time using a secondary matrix known as time history of the speckle pattern (THSP). To avoid being time consuming, the traditional way to build the THSP restricts the data to a line or column. Our hypothesis is that the spatial restriction of the information could compromise the results, particularly when undesirable and unexpected optical inhomogeneities occur, such as in cell culture media. It tested a spatial random approach to collect the points to form a THSP. Cells in a culture medium and in drying paint, representing homogeneous samples in different levels, were tested, and a comparison with the traditional method was carried out. An alternative random selection based on a Gaussian distribution around a desired position was also presented. The results showed that the traditional protocol presented higher variation than the outcomes using the random method. The higher the inhomogeneity of the activity map, the higher the efficiency of the proposed method using random points. The Gaussian distribution proved to be useful when there was a well-defined area to monitor.

This work presents the development of a protocol based on the dynamic laser speckle designed to monitor the reaction of cancer cells of line MEL-RC08 to the application of the drug Colcemid in two different concentrations: 0.2 and $0.4μg/mL$. The protocol was designed using the forward scattering approach with an He-Ne laser of 632.8 nm illuminating the samples, a control, and two variations of Colcemid, being monitored along 8 h. The data were analyzed numerically in the time and in the frequency domain, and the results presented the ability of the technique to monitor the action of the drug, particularly Colcemid ($0.4μg/mL$).

The dynamic laser-speckle phenomenon has been used as a potential tool to monitor the activity of many biological and nonbiological samples; however, a key tailoring of the experimental configuration must be taken into account to avoid wrong measurements, since the general rules addressed to speckle as information cannot be directly adopted in dynamic laser-speckle monitoring. The speckle/pixel size ratio is provided by the f-number and by the magnification of the macro lens, and attention is mainly directed toward adjusting a speckle/pixel ratio higher than 1. However, a speckle/pixel ratio much higher than one does not mean an optimum adjustment. This work tested different apertures with fixed magnification yielding to monitor a drying paint process. The outcomes were evaluated in the time and frequency domains. The highest speckle/pixel size ratio was not the best to monitor the process using the dynamic laser speckle under frequency analysis. Tailoring of the devices must take into account the optimum speckle/pixel size ratio, which could vary depending on the application, and the known Nyquist theorem cannot be considered as a sufficient condition since the setup of the optical camera with its macro and iris must also be adjusted in accordance with the frequency response.

Dynamic laser speckle (DLS) is used as a reliable sensor of activity for all types of materials. Traditional applications are based on high-rate captures (usually greater than 10 frames-per-second, fps). Even for drying processes in conservation treatments, where there is a high level of activity in the first moments after the application and slower activity after some minutes or hours, the process is based on the acquisition of images at a time rate that is the same in moments of high and low activity. In this work, we present an alternative approach to track the drying process of protective layers and other painting conservation processes that take a long time to reduce their levels of activity. We illuminate, using three different wavelength lasers, a temporary protector (cyclododecane) and a varnish, and monitor them using a low fps rate during long-term drying. The results are compared to the traditional method. This work also presents a monitoring method that uses portable equipment. The results present the feasibility of using the portable device and show the improved sensitivity of the dynamic laser speckle when sensing the long-term process for drying cyclododecane and varnish in conservation.