The agricultural activity of pruning olive trees generates waste which, due to long-standing practices and unawareness of the consequences, are burned on site, thereby producing CO₂ emissions in the atmosphere. Therefore, in order to prevent environmental pollution and a waste of resources, the aim of this research investigation was to highlight some alternative uses of the pruning of olive trees waste. This work focuses on recycled and reused by-products as a secondary raw material for the implementation of interior components that can be used for indoor acoustic correction purposes and evaluates their potential as absorbing materials, without overlooking the aesthetic dimension. In this paper, different configurations based on plywood frames with loose olive pruning chips used as a filler, namely, modules and sub-modules, were investigated. Moreover, other technological details, that is, the influence of a Tissue-Non-Tissue (TNT) layer and a spray film coating applied over the external surface of the loose material, were measured. Sound absorption measurements were conducted inside a small-scale reverberation room (SSRR) and the experimental results demonstrated that the samples, for the given thickness, have weighted sound absorption values (α_w) of between 0.15 and 0.35 and single third-octave band values that can reach higher values than 0.50 above 500 Hz. The frequency curves and weighted values of the samples in which the influence of TNT and the spray film coating were tested remained unchanged. This is a design aspect that allows absorbing surfaces to be modeled and integrated with existing walls, while maintaining the acoustic performance and the specific aesthetic features of the loose material.

Accurate thermal characterization of building insulation materials is essential for reliable energy performance assessment, regulatory compliance, and the development of high-performance envelopes. On one hand, the growing adoption of innovative insulating products, such as nanoporous materials, aerogel-based composites, bio-based panels, and thin insulating coatings, helps to enhance buildings’ energy efficiency by means of sustainable raw materials. On the other hand, conventional measurement techniques encounter significant challenges, due to their heterogeneity, reduced thickness, and unconventional geometries. In this study, an intra-laboratory comparison of three widely used methods for thermal conductivity determination is presented: the Transient Plane Source (TPS, Hot Disk) method, the Guarded Hot Plate (GHP) method, and the Heat Flow Meter (HFM) method. A total of twelve insulating materials, spanning super-insulating cores, insulating renders, bio-based panels, and nanocomposite coatings, were experimentally characterized under controlled laboratory conditions. A view on the analyzed insulating materials’ cradle-to-grave environmental impact is also given, to enhance the users’ awareness for the highly informed choice. The results highlight systematic differences between transient and steady-state approaches, with TPS measurements generally exhibiting larger deviations for materials characterized by surface roughness, limited thickness, or strong internal heterogeneity. In contrast, GHP and HFM methods show closer agreement when specimen geometry and stabilization requirements are satisfied. The influence of contact resistance, probing depth, specimen preparation, and uncertainty propagation is critically analyzed for each technique. The study provides practical insights into the applicability limits of commonly used thermal characterization methods and emphasizes the importance of selecting measurement techniques in relation to material morphology and testing constraints. These findings support more reliable thermal property assessment of emerging insulation materials and contribute to improved consistency between laboratory measurements and energy performance evaluations for buildings.