Here, we report the fabrication of TiO2/Fe2O3 core/shell heterojunction nanorod arrays by a pulsed laser deposition (PLD) process and their further use as photoelectrodes toward high-performance visible light photoelectrochemical (PEC) water splitting. The morphology, phase, and carrier conduction mechanism of plain TiO2 and TiO2/Fe2O3 core/shell nanostructure were systematically investigated. PEC measurements show that the TiO2/Fe2O3 core/shell nanostructure enhances photocurrent density by nearly 2 times than the plain ones, increases visible light absorption from 400 to 550 nm, raises the on/off separation rate, and delivers high stability with only a 3% decrease of current density for tests of even more than 14 days. This work provides a method to design an efficient nanostructure by combination of a facile hydrothermal process and high-quality PLD process to fabricate a clean surface and excellent crystallinity for charge separation, transfer, and collection toward enhanced PEC properties.
We report the successful growth of NiCo2S4 nanosheet films converted from NiCo2O4 nanosheet films on fluorine-doped tin oxide substrates by a low-temperature solution process. Low-cost NiCo2S4 and NiCo2O4 nanosheet films were directly used for replacing conventional Pt and NiO as counter electrodes and photocathodes, respectively, to construct all-nano p-type dye-sensitized solar cells (p-DSSCs) with high performance. Compared to Pt, NiCo2S4 showed higher catalytic activity towards the I-/I3 - redox in electrolyte, resulting in an improved photocurrent density up to 2.989 mA/cm2, which is the highest value in reported p-DSSCs. Present p-DSSCs demonstrated a cell efficiency of 0.248 % that is also comparable with typical NiO-based p-DSSCs.
Even though Fe2O3 is reported as the electron-transporting layer (ETL) in perovskite solar cells (PSCs), its fabrication and defects limit its performance. Herein, we report a Fe2O3 ETL prepared from FeCl3 solution with a dopant Fe3O4 nanoparticle modification. It is found that the mixed solution can reduce the defects and enhance the performance of Fe2O3 ETL, contributing to improved electron transfer and suppressed charge recombination. Consequently, the best efficiency is improved by more than 118% for the optimized device. The stability efficiency of the Fe2O3-ETL-based device is nearly 200% higher than that of the TiO2-ETL-based device after 7 days measurement under a 300 W Xe lamp. This work provides a facile method to fabricate environmentally friendly, high-quality Fe2O3 ETL for perovskite photovoltaic devices and provides a guide for defect passivation research.