Qian Lian

Ms. Qian Lian

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 December 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
QLQian Lian
Qian Lian
PHPeiqing Han
Peiqing Han
NMNiansong Mei
Niansong Mei
The Internet of Things (IoT) has a great number of sensor nodes distributed in different environments, and the traditional approach uses batteries to power these nodes: however, the resultant huge cost of battery replacement means that the battery-powered approach is not the optimal solution. Micro energy harvesting offers the possibility of self-powered sensor nodes. This paper provides an overview of energy harvesting technology, and describes the methods for extracting energy from various sources, including photovoltaic, thermoelectric, piezoelectric, and RF; in addition, the characteristics of the four types of energy sources and the applicable circuit structures are summarized. This paper gives the pros and cons of the circuits, and future directions. The design challenges are the efficiency and size of the circuit. MPPT, as an important method of improving the system efficiency, is also highlighted and compared.

28 October 2022 in Electronics
Verified
Journal Article
Open access
PDF file
RCRuihu Cao
Ruihu Cao
NMNiansong Mei
Niansong Mei
QLQian Lian
Qian Lian
This paper introduces a novel and efficient physical unclonable function (PUF) extraction method for SRAM. The proposed one-layer convolution scheme is based on a convolution operation, which significantly enhances the reliability of the PUF. To further reduce the hardware resources, a lightweight solution is presented based on a one-layer convolution scheme at the cost of a higher redundancy coefficient and a larger range for the inter-chip Hamming distance (HD). Both the above schemes only use certain hardware resources in the initial stage and the hardware resources are automatically released after PUF verification. The two schemes were verified using SRAM cells in three stm32f407 chips to output a 256-bit PUF response. The experimental results show that the one-layer convolution scheme required 8 KB SRAM, while the lightweight scheme used only 0.5 KB SRAM. The reliability of the one-layer convolution was found to be 100% when the redundancy coefficient was 0.08 and the inter-chip HD was 50.8073%. The reliability of the lightweight scheme was 100% and of the inter-chip HD was 50.195%.

25 March 2024 in Electronics
Verified
Journal Article
Open access
PDF file
QLQian Lian
Qian Lian
NMNiansong Mei
Niansong Mei
This paper presents a novel adaptive reconfigurable rectifier architecture for radio frequency energy harvesting (RFEH); in addition, a new metric for high-efficiency dynamic range (DR) is proposed. The presented rectifier architecture is based on a double-sided diode-feedback cross-coupled differential-drive rectifier (CCDR) structure incorporating self-body bias for reconfigurable operation. An adaptive structure based on a Schmitt trigger is proposed to adaptively switch the rectifier connection without auxiliary voltage (Vaux), with two rectifier stages in parallel at low power and in series at high power. The system is simulated at a 180 nm CMOS process and the results show more than 17 dB DR at 900 MHz, with efficiency higher than 50% at a 100 kΩ load.