Although research has found that using rubber in concrete will enhance its resilience and reduce its density, the significant loss of strength owing to lack of bonding has remained unresolved. This study considers how to minimise the loss of strength of concrete with used rubber tyre crumb aggregates and investigates the improvement of water permeability resistance that may consequentially develop. A surface of rubber crumb was modified by soaking in the saturated sodium hydroxide solution or silane coupling agent (SCA) before using. Up to 20% of natural fine aggregate was volumetrically replaced with treated rubber crumb. Experimental results show higher compressive and flexural strengths, Young's modulus and water permeability resistance from the samples with SCA-treated rubber than with as-received or sodium-hydroxide-treated rubber. X-ray diffraction pattern analyses indicate almost no change in crystalline phase for the rubber surface modification. Microscopic inspections show an enhanced rubber-matrix adhesion with the use of SCA. Results of mercury intrusion porosimetry reveal that concrete with SCA-treated rubber has a similar pore size distribution to the other three mixes, but achieves the lowest porosity and highest tortuosity, resulting in the best water permeability resistance. A brief cost analysis suggests that this method of surface modification is economically viable.
Plastic represents an environmental issue, as only 7% of it is recycled. The plastic remaining is either burned, disposed of in an uncontrolled manner, or landfilled. Thus, to reduce the quantity of plastic that is disposed of, there is a need to increase the amount of the material that enters various product streams. This includes its use in the construction industry, and more particularly in concrete, which uses large quantities of aggregate. A novel aggregate (RPA) comprising recycled plastic was developed. The aggregate produced was lightweight, with a density ranging from 510 to 750k kg/m3 and absorption of from 2.7 to 9.81%. Other properties were comparable to aggregates of similar densities. Various composition RPA was used in concrete, and the resulting properties of both fresh and cured concrete were measured. For a given water to cement (w/c) ratio, it was possible to achieve slump of between 40 and 220 mm and fresh density of between 1,827 and 2,055 kg/m3. Further, 28-day strengths of...
Conventional concrete is a common building material that is often ridden with cracks due to its low tensile strength. Moreover, it has relatively low shear strength and, unless reinforced, undergoes brittle failure under tension and shear. Thus, concrete must be adequately reinforced to prevent brittle tensile and shear failures. Steel fibres are commonly used for this purpose, which can partially or fully replace traditional steel reinforcement. The strength properties and bond characteristics between reinforcing steel fibres and the concrete matrix are crucial in ensuring the effective performance of the composite material. In particular, the quality of the bond has a significant impact on crack development, crack spacing, and crack width, among other parameters. Hence, the proper application of steel fibre-reinforced concrete (SFRC) requires a thorough understanding of the factors influencing its bond behaviour and strength properties. This paper offers a comprehensive review of the main factors controlling the bond behaviour between concrete and steel fibres in SFRC. In particular, we focus on the effects of the physical and mechanical properties of steel fibres (e.g., geometry, inclination angle, embedded length, diameter, and tensile strength) on the bond behaviour. We find that the addition of up to 2% of steel fibres into concrete mixtures can significantly enhance the compressive strength, tensile strength, and flexural strength of concrete components (by about 20%, 143%, and 167%, respectively). Furthermore, a significant enhancement in the pull-out performance of the concrete is observed with the addition of steel fibres at various dosages and geometries.