A variable aperture has been fabricated and demonstrated using polydimethylsiloxane-based optofluidic technology. The device consists of a deformable membrane, an air pressure chamber, a cavity filled with light-absorbing liquid, and a rigid transparent upper plate. The working principle of the device is based on the deformable capability of the thin membrane structure and its resultant contact with the rigid plate. The contact area can be easily controlled by varying the air volume introduced and hence can serve as a light transmission aperture. Experimental results show that aperture diameter can be continuously changed from zero to .
A novel liquid-filled lens design is presented. During fabrication, high precision single point diamond turning (SPDT) is introduced into standard soft lithography process to fabricate an aspherical surface constituting one end of lens. This enables the spherical aberration associated with the operation of the conventional liquid-filled lenses to be compensated for. Through flexibly optimizing this surface contour, it can be designed to work within particular working regions with improved optical quality. At the same time, the deformable elastic membrane is still adopted at the other end of the lens, thus preserving the high focal length tunability. This proof of concept and the performance of the proposed lens have been demonstrated using the lateral shearing interferometry experiment..
Aiming to pursue a micromirror possessing many desired characteristics, such as linear control, low power consumption, fast response, and easy fabrication, a new piezoelectric actuation strategy is presented. Different from conventional piezoelectric actuation cases, we first propose using AlN film as the active layer for actuating the micromirror. Owing to its good CMOS compatible deposition and patterning techniques, the AlN based piezoelectric micromirror has been successfully fabricated with a modified silicon-on-insulator-based microelectromechanical system (MEMS) process. At the same time, various mirror movement modes operating at high frequencies and excellent linear relationship between the movement and the control signal both have been experimentally demonstrated.
To address the serious acoustic performance deterioration induced by air leakage in the low-frequency range and the asynchronous vibration in electroacoustic transduction structures near the resonant frequency, a novel sealing strategy is proposed that targets one of the most widely reported piezoelectric MEMS speaker designs. This design consists of multiple cantilever beams, in which the air gaps between cantilevers are automatically and selectively filled with liquid polydimethylsiloxane (PDMS) via the capillary effect, followed by curing. In the proof-of-concept demonstration, the sound pressure level (SPL) within the frequency range lower than 100 Hz markedly increased after sealing in an experiment using an IEC ear simulator. Specifically, the SPL is increased by 4.9 dB at 20 Hz for a 40 Vpp driving voltage. Moreover, the deteriorated SPL response near the resonant frequencies of the cantilever beams (18 kHz–19 kHz) caused by their asynchronous vibration induced by the fabrication process nonuniformity also significantly improved, which successfully increased the SPL to approximately 17.5 dB. Moreover, sealed devices feature nearly the same SPL response as the initial counterpart in the frequency band from 100 Hz to 16 kHz and a total harmonic distortion (THD) of 0.728% at 1 kHz for a 40 Vpp driving voltage. Compared with existing sealing methods, the current approach offers easy operation, low damage risk, excellent repeatability/reliability and excellent robustness advantages and provides a promising technical solution for MEMS acoustic devices.