The paper presents the results of the synthesis and study of CuAl layered double hydroxides (LDHs) as well as their application as catalysts for the selective hydrogenation of crotonaldehyde. Phase-homogeneous LDHs were obtained by co-precipitation and mechanochemical methods, and critical parameters ensuring the formation of the target product were identified. In the case of coprecipitation, the formation of LDH is most affected by the pH of the reaction medium and the CO32−/Al3+ ratio. The optimal CO32−/Al3+ ratio is ca. 0.5–0.8 and pH 9.5–10.0. When mechanochemical synthesis is used, at 500 m·s−2 and 60 min, it is possible to obtain a single-phase CuAl LDH, whereas at higher energies, LDH is destroyed. The mechanochemical method makes it possible not only to reduce the synthesis time and the amount of alkaline wash water but also to obtain more dispersed copper particles with a higher hydrogenating activity. The conversion of 2-butenal (T = 80 °C, P = 0.5 MPa, 180 min, ethanol) for this sample was 99.9%, in contrast to 50.5% for the catalyst obtained by co-precipitation. It is important that, regardless of the conversion, both catalysts showed high selectivity (S = 90–95%) for the double bond hydrogenation.
1 December 2017 in Russian Journal of Applied Chemistry
The effect of chemical treatment (with nitric acid, sodium hydroxide, or superheated steam) of sapropel carbonization products on the properties of the final carbon–mineral materials was studied....
The research data on the preparation of nickel catalysts obtained from modified carbon mineral materials based on sapropel are given. The nature of these materials and their modification method were...
1 March 2016 in Chemistry and Technology of Fuels and Oils
Over the last 20 years, carbon-containing catalysts prepared using carbonized aluminum oxide and various carbon-based materials as carriers, along with metal carbides as active components, have been widely studied in the hydroprocessing of oil fractions. In this work, the properties of different groups of carbon-containing catalysts are discussed. The difficulties of using carbon-based carriers caused by their need for chemical pretreatment (oxidation and leaching), and the application of water–organic infiltrating solutions to form active catalyst components in finely dispersed form, is shown.
The investigations results of cobalt-molybdenum catalysts obtained using carbon-mineral materials from sapropel as support are presented. The effect of the support modification method (acidic, alkaline treatment, activation by water vapor) on the catalysts properties in the model transformation reactions of 1-methylnaphthalene and dibenzothiophene is shown. It was found that acidic treatment resulted in increased specific surface of carbon-mineral materials (with the preservation of a large-pored structure), supported metals dispersion, and to the formation of acidic centers on the surface. The use of a catalyst prepared with acidic treatment led to an increase in the conversion of methylnaphthalene and dibenzothiophene by about 4 and 3 times, respectively, compared to the initial sample without modification.