The paper presents the results of the synthesis and study of CuAl layered double hydroxides (LDHs) as well as their application as catalysts for the selective hydrogenation of crotonaldehyde. Phase-homogeneous LDHs were obtained by co-precipitation and mechanochemical methods, and critical parameters ensuring the formation of the target product were identified. In the case of coprecipitation, the formation of LDH is most affected by the pH of the reaction medium and the CO32−/Al3+ ratio. The optimal CO32−/Al3+ ratio is ca. 0.5–0.8 and pH 9.5–10.0. When mechanochemical synthesis is used, at 500 m·s−2 and 60 min, it is possible to obtain a single-phase CuAl LDH, whereas at higher energies, LDH is destroyed. The mechanochemical method makes it possible not only to reduce the synthesis time and the amount of alkaline wash water but also to obtain more dispersed copper particles with a higher hydrogenating activity. The conversion of 2-butenal (T = 80 °C, P = 0.5 MPa, 180 min, ethanol) for this sample was 99.9%, in contrast to 50.5% for the catalyst obtained by co-precipitation. It is important that, regardless of the conversion, both catalysts showed high selectivity (S = 90–95%) for the double bond hydrogenation.
The paper presents that the graphite mechanical activation (MA) results in the particles size reduction and crystal structure disorder. The estimation of the electric conductivity of high-dispersive graphite powders was performed and the specific electric resistance improving is represented to occur after MA by two orders at the grinding bodies acceleration (1000 m/s2). Thus MA cannot be used for the particles size reduction, the electric resistance value being kept at the initial graphite level in the intensive conditions. The electric resistance of the samples improves from 2 to 6 times after MA at the low grinding bodies acceleration (300 m/s2) therefore MA in the “mild conditions” is more perspective approach to the conductive carbon powders development with the preset particles size
We report on petroleum asphalt–based porous carbons with high textural characteristics, CO2/N2 adsorption capacity and selectivity. A series of samples was prepared by a two-stage method, including preliminary heat treatment of asphalt at 450°C and KOH activation. The activation temperature varied from 700 to 900°C. Correlation between the porous structure and adsorption properties of asphalt-based porous carbons on the activation temperature was obtained. The activation temperature of petroleum asphalt has a significant effect on the porous structure of the activated carbon materials. Thus, exclusively microporous sample is formed at the temperature of 700 °С. An increase in the activation temperature to 800°C leads to the formation of mesopores. The decrease in textural characteristics due to the formation of more stable carbon structures to gasification reactions takes place at a temperature of 900 °С. In addition, the adsorption capacity of CO2 was measured for carbon samples. The porous carbon activated at 700 °C and derived from petroleum asphalt exhibited high CО2 adsorption capacity of 6.3 mmol/g at 0 °C and 1 atm and good selectivity for CO2 over N2, indicating possible applications in CO2 capture technology.