This paper proposes a sliding-mode control (SMC)-based scheme for the variable-speed direct-driven wind energy conversion systems (WECS) equipped with a permanent magnet synchronous generator connected to the grid. In this paper, diode rectifier, boost converter, neutral point clamped inverter, and L filter are used as the interface between the wind turbine and grid. This topology has abundant features such as simplicity for low- and medium-power wind turbine applications. It is also less costly than back-to-back two-level converters in medium-power applications. The SMC approach demonstrates great performance in complicated nonlinear systems control such as WECS. The proposed control strategy modifies reaching law (RL) of the sliding mode technique to reduce chattering issue and to improve total harmonic distortion property compared to conventional RL SMC. The effectiveness of the proposed control strategy is explored by simulation study on a 4-kW wind turbine, and then verified by experimental tests for a 2-kW setup.

Having a reduced number of switches and isolated DC sources yet generating a higher number of voltage levels has been always the challenge when selecting the appropriate Multilevel Inverter (MLI) topology. Nowadays, Single-DC-Source Multilevel Inverter (SDCS-MLI) topologies are being considered as more suitable for many power system applications such as Renewable Energy (RE) conversion systems and electrified transportations compared to the Multiple-DC-Source MLIs (MDCS-MLIs). Moreover, increasing the power rating and minimizing the switching frequency while maintaining reasonable power quality using a SDCS-MLI is an important requirement and a persistent challenge for the industry. Thus, this paper presents a general review on available SDCS-MLI topologies and future trends. Existing solutions are discussed and analyzed based on their topologies, number of output voltage levels, number of active/passive components, advantages/limitations, maturity, and industrial applications. Furthermore, recommendations for future research and development are suggested in this paper

In this paper, a new mode of operation has been introduced for packed U-cell (PUC) inverter. A sensor-less voltage control based on redundant switching states is designed for the five-level packed U-cell (PUC5) inverter, which is integrated into switching process. The sensor-less voltage control is in charge of fixing the dc capacitor voltage at half of the dc source value results in generating symmetric five-level voltage waveform at the output with low harmonic distortion. The sensor-less voltage regulator reduces the complexity of the control system, which makes the proposed converter appealing for industrial applications. An external current controller has been applied for grid-connected application of the introduced sensor-less PUC5 to inject active and reactive power from inverter to the grid with arbitrary power factor, while the PUC auxiliary dc bus is regulated only by sensor-less controller combined with new switching pattern. Experimental results obtained in stand-alone and grid-connected operating modes of proposed PUC5 inverter prove the fast response and good dynamic performance of the designed sensor-less voltage control in balancing the dc capacitor voltage at desired level.

This paper proposes a modified conation of single-phase pack U-cell (PUC) multilevel inverter in which the output voltage has higher amplitude than the maximum dc link value used in the topology as a boost operation. The introduced inverter generates seven-level ac voltage at the output using two dc links and six semiconductor switches. Comparing to cascaded H-bridge and neutral point clamp multilevel inverters, the introduced multilevel inverter produces more voltage levels using less components. The proposed inverter is used in photovoltaic (PV) system where the green power comes from two separate PV panels connected to the dc links through dc-dc converters to draw the maximum power. Due to boost operation of this inverter, two different PV panels can combine and send their powers to the grid. Simulations and experimental tests are conducted to investigate the good dynamic performance of the inverter in grid-connected PV system.

This paper presents a closed-loop space vector modulation (SVM)-based sliding mode controller (SMC) for a three-level grid-connected neutral point clamped (3L-NPC) inverter. The nonlinear SMC based on Gao's reaching law has been designed to control the grid current and inject desired amount of active and reactive power into the network. Due to using single dc source at the NPC inverter dc bus, neutral point voltage is controlled through redundant switching states and instantaneous dc voltage feedback integrated into SVM technique. Meanwhile, there is no external voltage controller involved, thus no associated fine tuning issues are existed. The performance of the proposed hybrid controller to inject a desired active/reactive power to the grid is investigated through external perturbations such as change in the line current amplitude/phase shift, ac voltage fluctuation, as well as dc voltage variation. Full converter state-space model was developed and simulated. Experimental results are provided to verify the fast dynamic performance, low content of line current THD%, and good voltage balancing of dc bus capacitors of the NPC inverter.

In this paper, a new cascaded nonlinear controller has been designed and implemented on the packed U-cell (PUC) seven-level inverter. The proposed controller has been designed based on a simplified model of PUC inverter and consists of a voltage controller as an outer loop and a current controller as an inner loop. The outer loop regulates the PUC inverter capacitor voltage as the second dc bus. The inner loop is in charge of controlling the flowing current, which is also used to charge and discharge that capacitor. The main goal of the whole system is to keep the dc capacitor voltage at a certain level results in generating a smooth and quasi-sine-wave seven-level voltage waveform at the output of the inverter with low switching frequency. The proposed controller performance is verified through experimental tests. Practical results prove the good dynamic performance of the controller in fixing the PUC capacitor voltage for various and variable load conditions and yet generating low-harmonic seven-level voltage waveform to deliver power to the loads. Operation as an uninterruptible power supply (UPS) or ac loads interface for photovoltaic energy conversion applications is targeted.