2 April 2018 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This paper proposes a modified conation of single-phase pack U-cell (PUC) multilevel inverter in which the output voltage has higher amplitude than the maximum dc link value used in the topology as a boost operation. The introduced inverter generates seven-level ac voltage at the output using two dc links and six semiconductor switches. Comparing to cascaded H-bridge and neutral point clamp multilevel inverters, the introduced multilevel inverter produces more voltage levels using less components. The proposed inverter is used in photovoltaic (PV) system where the green power comes from two separate PV panels connected to the dc links through dc-dc converters to draw the maximum power. Due to boost operation of this inverter, two different PV panels can combine and send their powers to the grid. Simulations and experimental tests are conducted to investigate the good dynamic performance of the inverter in grid-connected PV system.
20 June 2019 in IEEE Access
This paper proposes a novel single-DC source multilevel inverter called Packed E-Cell topology to achieve nine-level with noticeably reduced components count while DC capacitors are actively balanced. The nine-level Packed E-Cell (PEC9) is composed of seven active switches, two DC capacitors that are shunted by a four-quadrant switch to from the E-Cell, and it makes use of a single DC-link. With the proper design of corresponding PEC9 switching states, the DC capacitors are balanced using redundant charging/discharging states. Since the shunted capacitors are horizontally extended, both capacitors are simultaneously charged or discharged with redundant states so as only the auxiliary DC-link voltage needs to be sensed and regulated to half of input DC source voltage and consequently DC capacitors voltages are inherently balanced to one quarter of the DC bus voltage. To this end, an active capacitor voltage balancing integrated to the level shift half parabola carrier PWM technique has been designed based on the redundant charging/discharging states to regulate the DC capacitors voltages of PEC9. Furthermore, using E-Cell not only reduces components count but also the proposed topology permits multi AC terminal operation. So, five-level inverter operation can be achieved during four-quadrant switch fault which confer to the structure high reliability. Theoretical analysis as well as experimental results are presented and discussed showing the basic operation, multi-functionality as well as the superior performance of the proposed novel PEC9 inverter topology.
5 March 2018 in IEEE Transactions on Power Electronics
In this paper, a modified selective harmonic mitigation pulse amplitude modulation (SHM-PAM) is presented to be capable of canceling all triplen harmonic orders and suitable for single-phase application of five-level type of voltage source inverters. To this end, a new constraint is established for the two switching angles (α 1 , α 2 ) to derive the new formula for the harmonics' amplitude, which results in self-elimination of all triplen harmonics (e.g., 3rd, 9th, 15th, ...). The fifth and seventh harmonic orders are mitigated through normal operation of the proposed SHM-PAM technique. It is also shown that the proposed technique is extendable to other multilevel voltage waveforms and a flowchart of self-elimination of all triplen harmonics has been presented. Mathematical analysis supported by experimental investigations show the desired performance of the proposed SHM-PAM algorithm on a two-cell single-phase cascaded H-bridge inverter as a typical five-level configuration in dealing with linear and nonlinear loads. Then, it is demonstrated that the maximum number of harmonic orders would be controlled with the minimum number of available angles in a low switching frequency voltage waveform.
14 January 2021 in IEEE Transactions on Industrial Electronics
Despite being cost-effective, seven-level Modified Packed U-Cell (MPUC7) active rectifier tends to be unstable due to unequal dc-links. Thus, a multiobjective controller is required to stabilize voltages and currents besides preserving efficiency and power quality. While conventional finite-set model predictive control (FSMPC) can deal with the multiobjective problem, it cannot assure the system stability, and its weighing factors tuning significantly becomes tiresome as the number of objectives increases. This article presents a low-frequency adaptive FSMPC (AMPC) stabilized based on Lyapunov stability theory to overcome the design problems of FSMPC. AMPC handles four control objectives and a decoupled stability objective. The control objectives assure the standard performance of MPUC7 in terms of switching losses, d v /d t , THD, and capacitors ripple. The stability objective guarantees the rectifier reliability under unstable conditions. The weighting factors in AMPC are floating to tackle the tuning challenges where a radial basis function neural network controller (RBFC) adjusts their variations. RBFC is trained by a novel self-training method including particle swarm optimization (PSO) algorithm and some mathematical analyses without using any training data. Experimental and simulation tests also evaluate AMPC in different conditions to confirm its reliability in fulfilling the desired objectives.
11 March 2020 in IEEE Transactions on Industrial Electronics
Seven-level Packed U-Cell (PUC7) is known as a cost-effective, low-component multilevel inverter. However, PUC7 challenge is the capacitor voltage balancing; so, it conventionally needs an additional voltage control integrated into the current control loop. Because of extra variables, control problem is further complicated for grid-connected PUC7. This paper proposes an Optimized Sliding Mode Control (OSMC) based on the current dynamical model to track the load current reference and to self-balance the capacitor voltage in both grid-connected and stand-alone operations. By optimizing the OSMC control factor using a Visual Based Optimization (VBO) method, PUC7 switching operation is controlled to self-balance the capacitor voltage while any extra voltage controller is needed. An adaptive control law has been also proposed for self-tuning of the PUC7 current reference to track the load and DC source variations. Experimental and simulation results of PUC7 prove the excellent performance of the proposed OSMC in achieving capacitor self-voltage balancing operation.
25 June 2020 in IEEE Transactions on Industrial Electronics
This paper proposes a Modified Finite-Set Model Predictive Control (M-FS-MPC) for multilevel switching mode operation of grid-connected nine-level Packed E-Cell (PEC9) inverter. With single-DC source, six power switches, back-to-back connected switches as bidirectional and two capacitors horizontally extended, PEC9 inverter topology has remarkably reduced components count. PEC prominent feature is the capability to switch among different multilevel voltage; nine- seven- or five- level under faulty switch case without any structure modification and only if the controller is appropriately designed. M-FS-MPC is proposed to operate grid-connected PEC with multilevel switching mode under bidirectional switch fault operation. Switching among five- seven- or nine-level voltages is attained by proper DC capacitors voltages regulation whereas the desired current injection with low THD and requested power factor for addressing grid connectivity applications is guaranteed. System discrete model is developed and experimental results verify the performance and robustness of M-FS-MPC in targeting the capability of PEC multilevel switching mode operation and grid connectivity requirements in both steady and transient states.