With the wide application of high-sensitivity broadband microwave receivers, the requirement of power-supply modulation ratio in receivers is greatly increased. Especially, the switched mode power-supply harmonics of the secondary converted power-supply in the satellite will inevitably produce spurious emissions in the receiver band. Therefore, it is necessary to analyze and prejudge the spurious response rejection ratio of the entire link from power-supply when designing a spaceborne high-sensitivity broadband receiver. The systematic theoretical formula of the spurious rejection ratio of each link is obtained by researching the influence of circuit design parameters, including the ratio of modules’ area to spacing, transistor bias voltage, frequency multiplying times, and sensitivity of the voltage-controlled oscillator. Taking a spaceborne Ka-band broadband receiver as an example, and the actual receiver is manufactured and measured for verification. By reducing the circuit area to 35 cm 2 , separating the module spacing to 0.1 mm, selecting a transistor gate bias voltage of −0.25 V, increasing the oscillator frequency to 3.25 GHz, and reducing the oscillator's voltage control sensitivity to 58 MHz/V, the optimal power supply switched spurious rejection ratio of nearly 60 dBc was ultimately achieved.
Multipactor-induced low-pressure Radio Frequency (RF) discharge has become increasingly critical in high-power planar integrated circuits under vacuum conditions, driven by the gradual increase in operating frequency, power, and system integration. However, the key factors determining the discharge threshold remain ambiguous due to the complexity of RF systems and convergence challenges in semi-open structure calculations. In this study, a planar circuit research model was constructed considering core factors including connection structure, bonding conditions, packaging, and substrate properties. To address the unique boundaries of semi-open structures, finite truncated boundaries were adopted for electron motion and electromagnetic field simulations, resolving issues of calculation accuracy and convergence. Using the particle-in-cell method, the discharge thresholds of models with different bonding structures and package boxes were numerically investigated, revealing a threshold discrepancy exceeding 6 dB. Experiments validate that when the package box is sufficiently large, the tightness and position of connection structures are the dominant factors affecting the discharge threshold. Conversely, when the package box is extremely small (only covering the planar circuit), it becomes the decisive factor. Secondary electron yield (SEY) measurements and microscopic composition analysis indicate that surface cleaning methods (atomization cleaning, ultrasonic cleaning, and hand scrubbing) exert a minor influence on SEY but barely alter the substrate composition. This work is the first to establish a threshold analysis framework for multipactor-induced low-pressure RF discharge in microwave planar circuits with practical processing states, providing actionable design guidelines for engineering applications.
With the increasing demand for multi-function and highly integrated space-borne microwave products, a three-dimensional heterogeneous integration based on special substrates and other systems-in-package has difficulty with meeting the requirements of high reliability in space. Through simulation, the thermal-deformation resistance of traditional interconnections meets the requirements of high reliability, but its transmission performance at high frequency is poor. Based on the above, a novel microwave horizontal coaxial transition structure with good thermal-deformation resistance and excellent microwave characteristics is proposed. The design formula of the structure is derived, and the basic size of the structure can be quickly calculated. The transition structure and a vertical matching structure can realize microwave interconnection by combining microstrip impedance transformation and gold-ribbon interconnection. The complex microwave circuit is laid out and partitioned in a three-dimensional way, and thus a space-borne microwave metallic system-in-package method based on high reliability microwave interconnections is implemented. A Ka-band receiving system-in-package is used as an example to carry out the actual test and validation. The better characteristics of the Ka-band receiving channel on the satellite are obtained, and its excellent reliability is verified by the temperature cycle and mechanical vibration test.