Qing Wang

Prof. Dr. Qing Wang


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 September 2019 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
QWQing Wang
Qing Wang
Hao ChenHao Chen
Hao Chen
HCHe Cheng
He Cheng
SYShuang Yan
Shuang Yan
SASaleem Abbas
Saleem Abbas
In this paper, an active boost power converter is proposed for switched reluctance generators (SRGs) that support low-voltage DC loads or DC microgrids. In the proposed converter, a front-end circuit is added to a conventional asymmetric half bridge power converter. With the front-end circuit, excitation voltage and demagnetization voltage can be regulated flexibly to improve the system efficiency and increase the maximum output power under constant phase current constraints. Then a multi-loop control strategy is developed to control the power converter. The multi-loop controller contains a power controller and a boost voltage controller. The power controller is designed to control SRG over the entire operating range. The boost voltage controller is designed to control the front-end circuit. Two strategies are compared for the boost voltage control: voltage hysteresis control strategy and power flow control strategy. Comparing with voltage hysteresis control, proposed power flow control shows improvements in minimizing output voltage ripple and is suggested for the proposed converter. In the end, simulation and experimental results are given to verify the feasibility of proposed power converter and control strategy. Comparisons between the proposed converter and the conventional converter are also given for evaluation.

5 July 2023 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
WYWenju Yan
Wenju Yan
WWWeichao Wang
Weichao Wang
HLHailong Li
Hailong Li
Hao ChenHao Chen
Hao Chen
FYFengyuan Yu
Fengyuan Yu
QWQing Wang
Qing Wang
In order to improve the torque performance and power density of switched reluctance motor, the combination of the axial flux and the radial flux is a suitable and effective method. Based on its operating principle and the characteristics of the hybrid flux structure, this article proposes the new axial-radial flux switched reluctance motors with different stator structures for electric vehicle applications. First, this article describes the topologies and operating principles of two stator structures. Then, the structural parameters of two kinds of motors are derived based on electromagnetic design principles. In order to evaluate the effects of different stator structures, the overall performance of the two proposed motors is studied using three-dimensional finite-element analysis, including the static magnetic characteristics and dynamic performance. Finally, a prototype motor is trialed, and the experimental results obtained are analyzed with the finite element results to verify the excellent performance of the proposed motor.

1 September 2018 in Biomicrofluidics
Verified
Journal Article
Open access
PDF file
XXXiao Xiao
Xiao Xiao
YZYuan Zhou
Yuan Zhou
YSYuqiong Sun
Yuqiong Sun
QWQing Wang
Qing Wang
JLJianbo Liu
Jianbo Liu
KWKemin Wang
Kemin Wang
Recombinant proteins have shown several benefits compared with their non-recombinant counterparts in protein therapeutics. However, there are still some problems with the storage and distribution of recombinant proteins, owing to their temperature sensitivity. Microfluidic chips can integrate different functional modules into a single device because of the advantages of integration and miniaturization, which have the special potential to synthesize drugs when and where they are needed most. Here, we integrated cell-free protein synthesis and purification into a microfluidic chip for the production of recombinant protein. The chip consisted of a main channel and a branch channel. The main channel included two pinches, which were filled with template DNA-modified agarose microbeads and nickel ion-modified agarose beads as the cell-free protein synthesis unit and protein purification unit, respectively. The reaction mixture for protein synthesis was introduced into the main channel and first passed through the protein synthesis unit where the target protein was synthesized; next, the reaction mixture passed through the protein purification unit where the target protein was captured; and, finally, pure protein was collected at the outlet when washing buffer and eluting buffer were sequentially introduced into the branch channel. Enhanced green fluorescent protein (EGFP) was used as the model to investigate the performance of our chip. One chip could produce 70 μl of EGFP solution (144.3 μg/ml, 10.1 μg) per batch, and another round of protein synthesis and purification could be performed after replacing or regenerating nickel ion-modified agarose beads. It should be possible to produce other recombinant proteins on demand with this chip by simply replacing the template DNA.

24 April 2025 in IEEE Transactions on Transportation Electrification
Verified
Journal Article
Closed access
WYWenju Yan
Wenju Yan
JXJun Xin
Jun Xin
KZKun Zhang
Kun Zhang
Hao ChenHao Chen
Hao Chen
YWYang Wang
Yang Wang
QWQing Wang
Qing Wang
To reduce the torque ripple in the phase change zone of the switched reluctance machine, a control approach combining the characteristics of the double stator switched reluctance machine (DSSRM) and the improved torque sharing function (TSF) control strategy is proposed. First, the state of the phase change zone is determined by comparing the torque prediction value with delay compensation and the reference torque value. Then, by setting the control parameters, the phase change zones of the inner and outer stators are completely staggered. On this basis, the reference torque is corrected online for each state of the phase change zone, aiming to achieve torque compensation by the torque of the other stator. Finally, the tracking of the corrected reference torque is realized by calculating the cost function. Through simulation and experimental verification, the proposed control strategy has a significant influence on suppressing torque ripple.

9 January 2024 in IEEE/ASME Transactions on Mechatronics
Verified
Journal Article
Closed access
WYWenju Yan
Wenju Yan
DZDong Zhang
Dong Zhang
KZKun Zhang
Kun Zhang
Hao ChenHao Chen
Hao Chen
HLHailong Li
Hailong Li
QWQing Wang
Qing Wang
This article proposes a novel drive system, which is applied to a novel double-stator switched reluctance motor (DSSRM). This motor has five work modes due to its structural characteristics, but the drive system composed of a traditional power converter cannot fully realize the five work modes. The drive system composed of the novel power converter can realize five work modes of the motor. First, the operating states of the novel power converter drive system in the five work modes are analyzed in this article, and the steady-state and transient simulation analyses are carried out. In addition, this article also analyzes the fault of the novel drive system and designs remedies to improve its reliability. Finally, a prototype of the 16/18/16 structure is fabricated and the drive system is built. The practical feasibility of the drive system is verified through experiments, which lays a theoretical foundation for the popularization and application of DSSRM in the field of electric vehicle drive system.

5 August 2019 in Sensors
Verified
Journal Article
Open access
PDF file
YYYukun Yang
Yukun Yang
Pengwen XiongPengwen Xiong
Pengwen Xiong
QWQing Wang
Qing Wang
QZQiang Zhang
Qiang Zhang
Herein, the problem of target tracking in wireless sensor networks (WSNs) is investigated in the presence of Byzantine attacks. More specifically, we analyze the impact of Byzantine attacks on the performance of a tracking system. First, under the condition of jointly estimating the target state and the attack parameters, the posterior Cramer–Rao lower bound (PCRLB) is calculated. Then, from the perspective of attackers, we define the optimal Byzantine attack and theoretically find a way to achieve such an attack with minimal cost. When the attacked nodes are correctly identified by the fusion center (FC), we further define the suboptimal Byzantine attack and also find a way to realize such an attack. Finally, in order to alleviate the negative impact of attackers on the system performance, a modified sampling importance resampling (SIR) filter is proposed. Simulation results show that the tracking results of the modified SIR filter can be close to the true trajectory of the moving target. In addition, when the quantization level increases, both the security performance and the estimation performance of the tracking system are improved.