The combination of the sonochemical activation of Ni(NO₃)₂ and Co(NO₃)₂ in the presence of Fe(NO₃)₃ and polyethylene glycol and consecutive heat treatment of the formed metal hydroxides offers a cheap and efficient method for the preparation of nickel ferrite and cobalt ferrite magnetic nanoparticles, which can be successfully applied in the selective capture of fluorescently derivatized N-glycans from human serum. XRD measurement revealed that, besides the ferrite phase, nickel and cobalt oxides also form during heat treatment. The amount of simple metal oxides can be well controlled by the temperature of the heat treatment, since increasing temperature yielded higher spinel content. For both nickel and cobalt, the best heat treatment temperature was found to be 673 K, where the samples contained 84.1% nickel ferrite, and in the case of cobalt, almost pure (99.6%) cobalt ferrite could be prepared. FT-IR and zeta potential measurements indicated the presence of surface OH groups, which aided in the dispersion of the particles in water and, in addition, can promote the adsorption of polar compounds. The practical applicability of the magnetic nanopowders was demonstrated in the purification of fluorescently derivatized N-glycans (from human serum). Cobalt ferrite was found to be the most effective. Owing to the easy preparation and the simplicity of the magnetic separation the pure cobalt ferrite, magnetic nanoparticles could be efficient tools for the selective enrichment of serum N-glycans in HPLC measurements.

A simplified, fast, and effective production method has been developed for the synthesis of manganese ferrite (MnFe₂O₄) magnetic nanoparticles (MNPs). In addition to the wide applicability of MnFe₂O₄ MNPs, this work also reports their application in DNA isolation for the first time. An ultrasonic-cavitation-assisted combustion method was applied in the synthesis of MnFe₂O₄ MNPs at different furnace temperatures (573 K, 623 K, 673 K, and 773 K) to optimize the particles’ properties. It was shown that MnFe₂O₄ nanoparticles synthesized at 573 K consist of a spinel phase only with adequate size and zeta potential distributions and superparamagnetic properties. It was also demonstrated that superparamagnetic manganese ferrite nanoparticles bind DNA in buffer with a high NaCl concentration (2.5 M), and the DNA desorbs from the MNPs by decreasing the NaCl concentration of the elution buffer. This resulted in a DNA yield comparable to that of commercial DNA extraction products. Both the DNA concentration measurements and electrophoresis confirmed that a high amount of isolated bacterial plasmid DNA (pDNA) with adequate purity can be extracted with MnFe₂O₄ (573 K) nanoparticles by applying the DNA extraction method proposed in this article.

The need for stable and well-defined magnetic nanoparticles is constantly increasing in biomedical applications; however, their preparation remains challenging. We used two different solvothermal methods (12 h reflux and a 4 min microwave, MW) to synthesize amine-functionalized zinc ferrite (ZnFe₂O₄-NH₂) superparamagnetic nanoparticles. The morphological features of the two ferrite samples were the same, but the average particle size was slightly larger in the case of MW activation: 47 ± 14 nm (Refl.) vs. 63 ± 20 nm (MW). Phase identification measurements confirmed the exclusive presence of zinc ferrite with virtually the same magnetic properties. The Refl. samples had a zeta potential of −23.8 ± 4.4 mV, in contrast to the +7.6 ± 6.8 mV measured for the MW sample. To overcome stability problems in the colloidal phase, the ferrite nanoparticles were embedded in polyvinylpyrrolidone and could be easily redispersed in water. Two PVP-coated zinc ferrite samples were administered (1 mg/mL ZnFe₂O₄) in X BalbC mice and were compared as contrast agents in magnetic resonance imaging (MRI). After determining the r1/r2 ratio, the samples were compared to other commercially available contrast agents. Consistent with other SPION nanoparticles, our sample exhibits a concentrated presence in the hepatic region of the animals, with comparable biodistribution and pharmacokinetics suspected. Moreover, a small dose of 1.3 mg/body weight kg was found to be sufficient for effective imaging. It should also be noted that no toxic side effects were observed, making ZnFe₂O₄-NH₂ advantageous for pharmaceutical formulations.

For pathogens identification, the PCR test is a widely used method, which requires the isolation of nucleic acids from different samples. This extraction can be based on the principle of magnetic separation. In our work, amine-functionalized magnesium ferrite nanoparticles were synthesized for this application by the coprecipitation of ethanolamine in ethylene glycol from Mg(II) and Fe(II) precursors. The conventional synthesis method involves a reaction time of 12 h (MgFe₂O₄-H&R MNP); however, in our modified method, the reaction time could be significantly reduced to only 4 min by microwave-assisted synthesis (MgFe₂O₄-MW MNP). A comparison was made between the amine-functionalized MgFe₂O₄ samples prepared by two methods in terms of the DNA-binding capacity. The experimental results showed that the two types of amine-functionalized magnesium ferrite magnetic nanoparticles (MNPs) were equally effective in terms of their DNA extraction yield. Moreover, by using a few minutes-long microwave synthesis, we obtained the same quality magnesium ferrite particles as those made through the long and energy-intensive 12-h production method. This advancement has the potential to improve and expedite pathogen identification processes, helping to better prevent the spread of epidemics.

Glycosylation is vital for well-functioning glycoproteins and is reportedly altered in chronic inflammatory disorders, including multiple sclerosis (MS). High-throughput quantitative measurement of protein glycosylation is challenging, as glycans lack fluorophore groups and require fluorescent labeling. The attachment of fluorescent tags to each glycan moiety necessitates sample clean-up for reliable quantitation. The use of magnetic particles in glycan sample preparation is reportedly an easy-to-use solution to accomplish large-scale biomarker discovery studies. In this study, NH₂-funtionalized magnetic nanoparticles were synthetized, characterized and applied for the glycosylation analysis of serum samples from patients diagnosed with multiple sclerosis and corresponding healthy controls. Serum samples were PNGase F digested and labeled by procainamide via reductive amination, followed by magnetic nanoparticle-based purification. The prepared samples were analyzed by hydrophilic interaction liquid chromatography, allowing for the relative quantitation of the individual glycan species. Significant glycosylation alterations were detected between MS patients and healthy controls, especially when analyzing the different gender groups.

The removal of cadmium from contaminated water remains a critical challenge due to its high toxicity, persistence, and limited treatability at low concentrations. In this study, we propose a novel algal–nanoparticle system that integrates cadmium adsorption by Chlorella vulgaris with zinc ferrite (ZnFe₂O₄) nanoparticle-assisted sedimentation, with the aim of addressing a significant operational challenge in algal remediation. The microalgal biomass demonstrated the capacity to remove cadmium with efficiencies exceeding 90%, facilitated by adsorption through surface functional groups. The incorporation of ZnFe₂O₄ nanoparticles promoted the formation of dense, magnetically responsive aggregates, significantly accelerating biomass settling without the necessity for additional chemical flocculants. The strategy’s efficacy is evidenced by its enhancement of metal removal and solid–liquid separation processes, which renders it a potentially scalable and environmentally sustainable approach for the treatment of cadmium-contaminated wastewater. The strategy holds relevance for effluents derived from mining, electroplating, fertilizer production and battery manufacturing.