Sreeram Sundaresh

Prof. Dr. Sreeram Sundaresh

Electrical and Computer Engineering, University of Central Florida, Orlando, Florida, USA
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2021 in ECS Journal of Solid State Science and Technology
Verified
Journal Article
Open access
PDF file
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
Shraddha Dhanraj NehateShraddha Dhanraj Nehate
Shraddha Dhanraj Nehate
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
Electrical and optical properties of transparent conducting Indium Oxide (In2O3) thin films were studied. These films were deposited by reactive RF sputtering process using Indium target in the presence of oxygen as reactive gas with argon. The pressure and the oxygen gas flow ratios during sputtering were varied to investigate their effect on the resistivity, optical transmission, refractive index, and optical bandgap of In2O3 thin films. The lowest reported resistivity in this study is 2 × 10−3 Ω-cm. The optical transmission was more than 80% in the wavelength range of 400 nm to 800 nm. The optical study revealed the wide optical bandgap of 3.712 eV and 3.875 eV of the deposited In2O3 films. The films showed refractive indices in the range of 1.99 to 2.22. The elemental composition of In2O3 films has been studied through X-ray Photoelectron Spectroscopy (XPS).

1 February 2022 in ECS Journal of Solid State Science and Technology
Verified
Journal Article
Open access
PDF file
ASAshwin Kumar Saikumar
Ashwin Kumar Saikumar
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
Shraddha Dhanraj NehateShraddha Dhanraj Nehate
Shraddha Dhanraj Nehate
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
In this research, CuGaO2 thin films were prepared on quartz substrates by radio frequency magnetron sputtering technique at 400 °C followed by subsequent annealing in N2 ambiance. The effects of annealing temperature on structural, morphological, optical, and electrical properties of CuGaO2 thin films are reported in this work. X-ray Diffraction (XRD) analysis confirmed the presence of single-phase CuGaO2 in the film annealed at 900 °C. Near stoichiometric composition ratio of Cu:Ga (1:1.08) was identified in the film annealed at 900 °C. The Field Emission Scanning Electron Microscope (FESEM) images showed an increase in the grain size with an increase in annealing temperature. A UV–V is spectrophotometer was used to perform optical studies in the 200–800 nm wavelength region on all films. The optical bandgap was calculated from the transmission studies and was found to be in the range of 2.77 to 3.43 eV. The films annealed at temperatures 800 °C and above were found to be p-type. The lowest resistivity value of 230 Ω-cm was achieved in the film annealed at 900 °C.

1 June 2022 in ECS Journal of Solid State Science and Technology
Verified
Journal Article
Open access
ASAshwin Kumar Saikumar
Ashwin Kumar Saikumar
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
For the first time, this research focuses on the deposition and characterization of radio frequency (RF) sputtered p-type CuGaO2 thin films using the dual-target sputtering technique with Cu and Ga2O3 targets. The sputtering power to the Cu target was varied from 5 W to 50 W while having the Ga2O3 sputtering power constant at 200 W. The deposited films were subsequently annealed at two different annealing temperatures of 800 °C and 900 °C in N2 ambiance. The effects of variation in Cu sputtering power and annealing temperature on structural, optical, and electrical properties of CuGaO2 thin films are reported in this work. Single-phase CuGaO2 was confirmed in films deposited with Cu sputtering power of 25 W by XRD analysis. XPS analysis revealed a near stoichiometric composition ratio of Cu:Ga in films deposited with Cu sputtering power of 25 W. The optical studies were performed in 200 nm–800 nm wavelengths on all the post-deposition annealed films. The optical transmission was found to decrease with an increase in Cu sputtering power. The optical bandgap was found to be between 3.3 and 4.6 eV. Single-phase CuGaO2 film was p-type with a resistivity of 60 Ω-cm. This resistivity value is one of the lowest ever reported values identified from CuGaO2 thin films.

1 August 2021 in Coatings
Verified
Journal Article
Open access
PDF file
ASAshwin Kumar Saikumar
Ashwin Kumar Saikumar
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
Shraddha Dhanraj NehateShraddha Dhanraj Nehate
Shraddha Dhanraj Nehate
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
Thin films of CuGa2O4 were deposited using an RF magnetron-sputtering technique for the first time. The sputtered CuGa2O4 thin films were post-deposition annealed at temperatures varying from 100 to 900 °C in a constant O2 ambience for 1.5 h. Structural and morphological studies were performed on the films using X-ray diffraction analysis (XRD) and a Field Emission Scanning Electron Microscope (FESEM). The presence of CuGa2O4 phases along with the CuO phases was confirmed from the XRD analysis. The minimum critical temperature required to promote the crystal growth in the films was identified to be 500 °C using XRD analysis. The FESEM images showed an increase in the grain size with an increase in the annealing temperature. The resistivity values of the films were calculated to range between 6.47 × 103 and 2.5 × 108 Ωcm. Optical studies were performed on all of the films using a UV-Vis spectrophotometer. The optical transmission in the 200–800 nm wavelength region was noted to decrease with an increase in the annealing temperature. The optical bandgap value was recorded to range between 3.59 and 4.5 eV and showed an increasing trend with an increase in the annealing temperature.

1 April 2023 in ECS Journal of Solid State Science and Technology
Verified
Journal Article
Open access
PDF file
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
ABAkash Hari Bharath
Akash Hari Bharath
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
The deposition of CuInO2 films was achieved for the first time through a dual-target RF magnetron sputtering technique using Cu and In2O3 targets. It is found that the sputtering power of the Cu target has a significant effect on the structural, morphological, and optical characteristics of the films. The sputtering power of Cu was varied from 5 W to 50 W while the sputtering power of In2O3 was held constant at 50 W. From the XRD analysis, it was confirmed that pure-phase CuInO2 was obtained at a Cu sputtering power of 5 W. XPS analysis revealed that Cu exists in the oxidation state of 1+ in the films sputtered with 5 W Cu, further confirming the successful synthesis of single-phase CuInO2. The oxidation states of Cu and In, full-width half maximum (FWHM), peak positions, satellite peak positions, and their respective binding energies have been elucidated through XPS analysis. Nanocrystalline growth was confirmed through SEM analysis performed on all the post-deposition annealed films. Further, it was observed that grain size increased from 18.49 nm to 63.34 nm as Cu sputtering power is increased from 5 W to 50 W. The optical studies were performed on the post-deposition annealed films in the 300–800 nm wavelength range. The optical transmission and the optical bandgap were found to decrease with an increase in the Cu sputtering power. The highest transmission of ∼75% and the highest bandgap of 3.62 eV was obtained for the films showing single-phase CuInO2.

22 January 2023 in Coatings
Verified
Journal Article
Open access
PDF file
Sreeram SundareshSreeram Sundaresh
Sreeram Sundaresh
ABAkash Hari Bharath
Akash Hari Bharath
KSKalpathy B. Sundaram
Kalpathy B. Sundaram
For the first time, the deposition of CuCrO2 thin films was carried out using a dual-target RF magnetron sputtering technique using Cu2O and Cr2O3 targets. The deposited films were subsequently annealed in N2 ambiance from 600–900 °C. This work reports that the electrical, optical, structural, and morphological properties of CuCrO2 thin films are significantly affected due to the variation in the annealing temperature. XRD analysis confirms the presence of single-phase CuCrO2 in the films annealed at 650 °C. The presence of Cu in the 1+ oxidation state in the phase pure CuCrO2 thin films was confirmed through XPS analysis. Further, through XPS analysis, the oxidation states of Cu and Cr, the full-width half maximum (FWHM), the peak positions, and their respective binding energies have been elucidated. SEM analysis confirms the promotion of nanocrystalline growth in the thin films as the annealing temperature was increased from 600 °C. The average grain size increased from 40.22 nm to 105.31 nm as the annealing temperature was increased from 600 to 900 °C. Optical studies conducted in the wavelength range of 200 nm to 800 nm revealed a decrease in the optical transmission and optical bandgap with an increase in the annealing temperature. The highest optical transmission of ~81% and an optical bandgap of 3.21 eV were obtained for the films depicting the delafossite nature of CuCrO2. The optical bandgap was found to vary between 3.16 eV and 3.74 eV for the films studied in this research. The lowest resistivity of 0.652 Ω cm was obtained for the films annealed at 650 °C. Transparent heterojunction diodes involving p-type delafossite copper chromium oxide (CuCrO2) and n-type indium tin oxide (ITO) were fabricated. The best diode depicted a cut-in voltage of 0.85 V, a very low leakage current of 1.24 x 10-8, an ideality factor of 4.13, and a rectification ratio of 2375.