To achieve the full potential of monolithic perovskite/silicon tandem solar cells, crystal defects and film inhomogeneities in the perovskite top cell must be minimized. We discuss the use of methylenediammonium dichloride as an additive to the perovskite precursor solution, resulting in the incorporation of in situ–formed tetrahydrotriazinium (THTZ-H + ) into the perovskite lattice upon film crystallization. The cyclic nature of the THTZ-H + cation enables a strong interaction with the lead octahedra of the perovskite lattice through the formation of hydrogen bonds with iodide in multiple directions. This structure improves the device power conversion efficiency (PCE) and phase stability of 1.68 electron volts perovskites under prolonged light and heat exposure under 1-sun illumination at 85°C. Monolithic perovskite/silicon tandems incorporating THTZ-H + in the perovskite photo absorber reached a 33.7% independently certified PCE for a device area of 1 square centimeter.
Thermally evaporated C60 is a near-ubiquitous electron transport layer in state-of-the-art p–i–n perovskite-based solar cells. As perovskite photovoltaic technologies are moving toward industrialization, batch-to-batch reproducibility of device performances becomes crucial. Here, we show that commercial as-received (99.75% pure) C60 source materials may coalesce during repeated thermal evaporation processes, jeopardizing such reproducibility. We find that the coalescence is due to oxygen present in the initial source powder and leads to the formation of deep states within the perovskite bandgap, resulting in a systematic decrease in solar cell performance. However, further purification (through sublimation) of the C60 to 99.95% before evaporation is found to hinder coalescence, with the associated solar cell performances being fully reproducible after repeated processing. We verify the universality of this behavior on perovskite/silicon tandem solar cells by demonstrating their open-circuit voltages and fill factors to remain at 1950 mV and 81% respectively, over eight repeated processes using the same sublimed C60 source material. Notably, one of these cells achieved a certified power conversion efficiency of 30.9%. These findings provide insights crucial for the advancement of perovskite photovoltaic technologies towards scaled production with high process yield.
3 January 2022 in The Journal of Physical Chemistry Letters
The interfacial Dzyaloshinskii–Moriya interaction (DMI) is an essential ingredient for stabilizing chiral spin configurations in spintronic applications. Here, via first-principles calculations, we reveal the influence of lattice strain on DMI in Co/Pt interface. We observed a considerable enhancement for a certain lattice strain. Furthermore, a direct correlation is established between the DMI and interlayer distances dominated by the strain, which is attributed to a hybridization of electronic orbitals. This hybridization has also been presented as the microscopic origin of the interfacial DMI. We anticipate that our predictions provide new insights into the control of interfacial DMI for skyrmion-based spintronic devices.