The impact of sarcopenia on atherosclerotic cardiovascular disease remains unclear. We aimed to investigate the prognostic impact of sarcopenia on coronary artery disease (CAD). A total of 475 patients with CAD who underwent successful percutaneous coronary intervention (PCI) and computed tomography (CT) were enrolled. The cross-sectional area of skeletal muscle at the first lumbar (L1) vertebral level was measured, and sex-specific cut-off values of L1 skeletal muscle index (L1 SMI; male <31.00 cm²/m², female <25.00 cm²/m²) were obtained. The primary outcome was 3-year all-cause mortality and the secondary outcome was 3-year major adverse cardiovascular events (MACEs). Low L1 SMI was present in 141 (29.7%) of 475 patients. The incidence of all-cause mortality (23.7% vs. 5.9%, p < 0.001) and MACEs (39.6% vs. 11.8%, p < 0.001) was significantly higher in patients with low L1 SMI than in those with high L1 SMI. In multivariate analysis, low L1 SMI was an independent predictor of higher risk of all-cause mortality (hazard ratio (HR): 4.07; 95% confidence interval (CI): 1.95–8.45; p < 0.001) and MACEs (HR: 3.76; 95% CI: 2.27–6.23; p < 0.001). These findings remained consistent after propensity score-matched analysis with 91 patient pairs (C-statistic = 0.848). CT-diagnosed low skeletal muscle mass is a powerful predictor of adverse outcomes in patients with CAD undergoing PCI.

To evaluate diagnostic efficacy of deep learning (DL)-based automated bone mineral density (BMD) measurement for opportunistic screening of osteoporosis with routine computed tomography (CT) scans. A DL-based automated quantitative computed tomography (DL-QCT) solution was evaluated with 112 routine clinical CT scans from 84 patients who underwent either chest (N:39), lumbar spine (N:34), or abdominal CT (N:39) scan. The automated BMD measurements (DL-BMD) on L1 and L2 vertebral bodies from DL-QCT were validated with manual BMD (m-BMD) measurement from conventional asynchronous QCT using Pearson’s correlation and intraclass correlation. Receiver operating characteristic curve (ROC) analysis identified the diagnostic ability of DL-BMD for low BMD and osteoporosis, determined by dual-energy X-ray absorptiometry (DXA) and m-BMD. Excellent concordance were seen between m-BMD and DL-BMD in total CT scans (r = 0.961/0.979). The ROC-derived AUC of DL-BMD compared to that of central DXA for the low-BMD and osteoporosis patients was 0.847 and 0.770 respectively. The sensitivity, specificity, and accuracy of DL-BMD compared to central DXA for low BMD were 75.0%, 75.0%, and 75.0%, respectively, and those for osteoporosis were 68.0%, 80.5%, and 77.7%. The AUC of DL-BMD compared to the m-BMD for low BMD and osteoporosis diagnosis were 0.990 and 0.943, respectively. The sensitivity, specificity, and accuracy of DL-BMD compared to m-BMD for low BMD were 95.5%, 93.5%, and 94.6%, and those for osteoporosis were 88.2%, 94.5%, and 92.9%, respectively. DL-BMD exhibited excellent agreement with m-BMD on L1 and L2 vertebrae in the various routine clinical CT scans and had comparable diagnostic performance for detecting the low-BMD and osteoporosis on conventional QCT.

Lee KC, et al. Korean J Radiol. 2021 Oct;22:e127. https://doi.org/10.3348/kjr.2020.1468