A new type of hybrid atom-light interferometer is demonstrated with atomic Raman amplification processes replacing the beam splitting elements in a traditional interferometer. This nonconventional interferometer involves correlated optical and atomic waves in the two arms. The correlation between atoms and light developed with the Raman process makes this interferometer different from conventional interferometers with linear beam splitters. It is observed that the high-contrast interference fringes are sensitive to the optical phase via a path change as well as the atomic phase via a magnetic field change. This new atom-light correlated hybrid interferometer is a sensitive probe of the atomic internal state and should find wide applications in precision measurement and quantum control with atoms and photons.
Quantum memories are essential for quantum information processing. Techniques have been developed for quantum memory based on atomic ensembles. The atomic memories through optical resonance usually suffer from the narrow-band limitation. The far off-resonant Raman process is a promising candidate for atomic memories due to broad bandwidths and high speeds. However, to date, the low memory efficiency remains an unsolved bottleneck. Here, we demonstrate a high-performance atomic Raman memory in 87Rb vapour with the development of an optimal control technique. A memory efficiency of above 82.0% for 6 ns~20 ns optical pulses is achieved. In particular, an unconditional fidelity of up to 98.0%, significantly exceeding the no-cloning limit, is obtained with the tomography reconstruction for a single-photon level coherent input. Our work marks an important advance of atomic memory towards practical applications in quantum information processing.
In the past few decades, optical magnetometry has experienced remarkable development and reached to an outstanding sensitivity. For magnetometry based on optical readout of atomic ensemble, the fundamental limitation of sensitivity is restricted by spin projection noise and photon shot noise. Meanwhile, in practical applications, ambient magnetic noise also greatly limits the sensitivity. To achieve the best sensitivity, it is essential to find an efficacious way to eliminate the noises from different sources, simultaneously. Here, we demonstrate a quantum magnetic gradiometer with sub-shot-noise sensitivity using entangled twin beams with differential detection. The quantum enhancement spans a frequency range from 7 Hz to 6 MHz with maximum squeezing of 5.5 dB below the quantum noise limit. The sensitivity of gradiometer reaches 18 fT/cm at 20 Hz. Our study inspires future possibilities to use quantum-enhanced technology in developing sensitive magnetometry for practical applications in noisy and physically demanding environments.
Rydberg microwave (MW) sensors are superior to conventional antenna-based techniques because of their wide operating frequency range and outstanding potential sensitivity. Here, we demonstrate a Rydberg microwave receiver with a high sensitivity of and broad instantaneous bandwidth of up to . Such excellent performance was achieved by the amplification of one generated sideband wave induced by the strong coupling field in the six-wave mixing process of the Rydberg superheterodyne receiver, which was well predicted by our theory. Our system, which possesses a uniquely enhanced instantaneous bandwidth and high-sensitivity features that can be improved further, will promote the application of Rydberg microwave electrometry in radar and communication.
In a quantum memory scheme with the Raman process, the read process encounters noise from four-wave mixing (FWM), which can destroy the nonclassical properties of the generated quantum fields. Here we demonstrate experimentally that the noise from FWM can be greatly suppressed by simply reducing the FWM transition channels with a circularly polarized read beam while at the same time retaining relatively high retrieval efficiency.
Collective atomic excitation can be realized by the Raman scattering. Such a photon-atom interface can form an SU(1,1)-typed atom-light hybrid interferometer, where the atomic Raman amplification processes take the place of the beam splitting elements in a traditional Mach-Zehnder interferometer. We numerically calculate the phase sensitivities and the signal-to-noise ratios (SNRs) of this interferometer with the method of homodyne detection and intensity detection, and give their differences of the optimal phase points to realize the best phase sensitivities and the maximal SNRs from these two detection methods. The difference of the effects of loss of light field and atomic decoherence on measure precision is analyzed.