Molten marks identified at a fire site can aid in determining the cause of a fire. Quantitative analysis of such molten marks has not yet been reported, despite several identification methods for molten marks being proposed based on optical micrographs. Herein, we propose a new methodology to establish the quantitative microstructure parameters of the molten marks using electron backscatter diffraction (EBSD). The globules were generated by heating the copper conductor to 1100°C in a non-energized state. Then, the arc beads were prepared by shorting the copper wire at 25°C and 900°C in an energized state. The globules did not show evident demarcation lines and indicated that the microstructure consisted of globular or dendritic grains; this demonstrated that their characteristics were distinctly different from those of arc beads. However, the primary arc beads (PABs) shorted at 25°C exhibited a strong (001) texture perpendicular to the demarcation line and comprised large fractions of columnar grains with a small grain aspect ratio (GAR). The microstructure of secondary arc beads (SABs) shorted at 900°C presented a mixture of elongated and equiaxed grains with a large GAR and no specific development of texture. The GAR and (001) fraction perpendicular to the demarcation line could be discriminant parameters of PABs and SABs. Consequently, EBSD methods can be newly applied for the classification of globules, PABs, and SABs based on the quantitative microstructure information and orientation distribution.
4 May 2005 in Journal of the Science of Food and Agriculture
The microstructure of molten marks changes according to ambient temperatures, when a short circuit occurs. Investigation of microstructural changes is important for understanding the properties of copper and examining the cause of a fire. In this study, the boundary characteristics and grain-size distribution of molten marks—primary-arc beads (PABs), which short-circuited at room temperature (25 °C), and secondary-arc beads (SABs), which short-circuited at high temperatures (600 °C, 900 °C)—were compared using electron backscatter diffraction. The distribution of Σ3 boundaries was compared, and it was found that SABs have a higher fraction of Σ3 boundaries than PABs. Moreover, it was confirmed that the ratio of maximum grain size (area) to the total area of the molten mark in SABs is larger than that in PABs. Thus, reliable discriminant factors were suggested, such as the fraction of Σ3 boundaries and normalized maximum grain size, which can distinguish PABs and SABs. The four discriminant factors, such as the (001)//LD, GAR, fraction of Σ3 boundaries, and fraction of maximum grain size to the total molten-mark area, were verified using the machine learning of t-SNE and Pearson correlation analyses.
The copper molten marks at a fire site provide important clues for determining the causes of fire. Four factors have been presented to quantitatively discriminate copper molten marks, namely the fraction of (001) component perpendicular to the demarcation line, the grain aspect ratio, the fraction of Σ3 boundaries, and the fraction of maximum grain size. However, only laboratory-level results of these parameters have been presented, and their applicability in actual fires is yet to be verified. In this study, a fire reproduction experimental system was configured to generate molten marks similar to those in actual fire sites. The molten marks were measured by electron backscatter diffraction and applied to the four discriminant factors. The results obtained similar characteristics to those of the laboratory unit, confirming the applicability of the four discriminant factors. Discriminant equations and processes that can distinguish the primary and secondary arc beads were derived using the molten marks generated in the laboratory and reproduction experiments. Furthermore, a probabilistic discrimination method and classification model developed by machine learning were proposed. Therefore, the use of the discriminants in actual fires can improve the reliability of the statistics and prevent the recurrence of similar fires.