Preferential flow induced by desiccation cracks (PF-DC) has been proven to be an important hydrological effect that could cause various geotechnical engineering and ecological environment problems. Investigation on the PF-DC remains a great challenge due to the soil shrinking–swelling behavior. This work presents an experimental and numerical study of the PF-DC considering the dynamic changes of desiccation cracks. A soil column test was conducted under wetting–drying cycles to investigate the dynamic changes of desiccation cracks and their hydrological response. The ratios between the crack area and soil matrix area (crack ratio), crack aperture and depth were measured. The soil water content, matrix suction and water drainage were monitored. A new dynamic dual-permeability preferential flow model (DPMDy) was developed, which includes physically consistent functions in describing the variation of both porosity and hydraulic conductivity in crack and matrix domains. Its performance was compared to the single-domain model (SDM) and rigid dual-permeability model (DPM) with fixed crack ratio and hydraulic conductivity. The experimental results showed that the maximum crack ratio and aperture decreased when the evaporation intensity was excessively raised. The self-closure phenomenon of cracks and increased surficial water content was observed during low-evaporation periods. The simulation results showed that the matrix evaporation modeled by the DPMDy is lower than that of the SDM and DPM, but its crack evaporation is the highest. Compared to the DPM, the DPMDy simulated a faster pressure head building-up process in the crack domain and higher water exchange rates from the crack to the matrix domain during rainfall. Using a fixed crack ratio in the DPM, whether it is the maximum or the average value from the experiment data, will overestimate the infiltration fluxes of PF-DC but underestimate its contribution to the matrix domain. In conclusion, the DPMDy better described the underlying physics involving crack evolution and hydrological response with respect to the SDM and DPM. Further improvement of the DPMDy should focus on the hysteresis effect of the soil water retention curve and soil deformation during wetting–drying cycles.
The China-Pakistan Economic Corridor (CPEC) is an ongoing mega-construction project in Pakistan that necessitates further exploration of new natural resources of aggregate to facilitate the extensive construction. Therefore, the Late Permian strata of Chhidru and Wargal Limestone for aggregates resources were envisaged to evaluate their optimal way of construction usage through detailed geotechnical, geochemical, and petrographic analyses. Geotechnical analysis was performed under BS and ASTM standards with the help of employing different laboratory tests. A simple regression analysis was employed to ascertain mutual correlations between physical parameters. Based on the petrographic analysis, the Wargal Limestone is classified into mudstones and wackestone, and Chhidru Formation is categorized into wackestone and floatstone microfacies, both containing primary constituents of calcite and bioclasts. The geochemical analysis revealed that the Wargal Limestone and Chhidru Formation encompass calcium oxide (CaO) as the dominant mineral content. These analyses also depicted that the Wargal Limestone aggregates bear no vulnerability to alkali-aggregate reactions (AAR), whereas the Chhidru Formation tends to be susceptible to AAR and deleterious. Moreover, the coefficient of determination and strength characteristics, for instance, unconfined compressive strength and point load test were found inversely associated with bioclast concentrations and directly linked to calcite contents. Based on the geotechnical, petrographic, and geochemical analyses, the Wargal Limestone proved to be a significant potential source for both small and large-scale construction projects, such as CPEC, but the Chhidru Formation aggregates should be used with extra caution due to high silica content.
9 May 2020 in Geotechnical and Geological Engineering