The paper features a computational fluid dynamics study of a flapping NACA0015 hydrofoil moving with a combination of sinusoidal heaving and pitching. Several kinematic configurations are explored, varying sequentially pitch and heave amplitude, Strouhal number and phase angle, in an attempt to determine the influence of each parameter on the propulsive performance. To optimize efficiency the angle of attack should assume the highest value that also avoids the arise of the leading edge vortex generated in the dynamic stall state. At low Strouhal number optimum is reached at high heave amplitudes, which correspond to the configurations minimizing the hysteresis in the plane. The same outcome in terms of hysteresis minimization has been verified to occur when optimal phase shift was considered. Differently, when the Strouhal number and the angle of attack become higher, to exploit efficiently the lift increment owed to dynamic stall it emerged the necessity of adopting low heave amplitude to improve separation resistance, avoiding the occurrence of deep stall.
Numerical simulations based on a high-order discontinuous Galerkin solver were performed to investigate two-dimensional flapping foils at moderate Reynolds numbers, moving with different prescribed harmonic motion laws. A Spalart–Allmaras RANS model with and without an algebraic local transition modification was employed for the resolution of multiple kinematic configurations, considering both moderate-frequency large-amplitude flapping and high-frequency small-amplitude pure heaving. The propulsive performance of the airfoils with the two modelling approaches were tested by referring to experimental and (scale-resolving) numerical data available in the literature. The results show an increase in effectiveness in predicting loads when applying the transition model. This is particularly true at low Strouhal numbers when, after laminar separation at the leading edge, vorticity dynamics appears to have a strong effect on the forces exerted on the profile. Specifically, the transition model more accurately predicts the wake topology emerging in the flow field, which is the primary influence on thrust/drag generation.
This article presents a comparison between the performance obtained by using a spatial discretization of the Euler equations based on a high-order discontinuous Galerkin (dG) method and different sets of variables. The sets of variables investigated are as follows: (1) conservative variables; (2) primitive variables based on pressure and temperature; (3) primitive variables based on the logarithms of pressure and temperature. The solution is advanced in time by using a linearly implicit high-order Rosenbrock-type scheme. The results obtained using the different sets are assessed across several canonical unsteady test cases, focusing on the accuracy, conservation properties and robustness of each discretization. In order to cover a wide range of physical flow conditions, the test-cases considered here are (1) the isentropic vortex convection, (2) the Kelvin–Helmholtz instability and (3) the Richtmyer–Meshkov instability.