The yarn suction gun (YSG) is used to draw the running yarn in the initial phase and when changing the bobbin in a continuous yarn production and is usually operated with compressed air. With a typical overall efficiency of compressed air generation, treatment and delivery, the electrical power requirement increases to over 75 kW just to operate a single YSG. Such high electrical power consumption must be addressed. One of the most effective ways to reduce the cost of compressed air generation and treatment is to replace the existing technology with one that is less energy intensive. Based on centrifugal blowers used in vacuum cleaners, a prototype was built and connected to various mixing chambers. Simulations and measurements were performed to evaluate the tension force acting on the yarn. Research on the use of vacuum for yarn suction is presented. It is estimated that after optimizing the suction by using vacuum, only 20 kW of electrical power will be required for one YSG, halving the cost of the current approach using compressed air generation.
Accurate wind turbine noise (WTN) measurements are essential for environmental compliance and noise impact assessments. However, these measurements are often polluted by background biological noise, especially from insects. Insect noise is typically assumed to be irrelevant due to frequency separation. This study challenges this assumption by demonstrating that insect sounds, specifically those of the cricket Oecanthus pellucens, can overlap with turbine noise in the 2.5 kHz band and introduce significant measurement bias at low wind speeds. The featured application is a machine learning-based methodology to filter confounding biological sounds (e.g., insect calls) from wind turbine noise measurements. By correcting for these acoustic contaminants, which typically lead to an overestimation of turbine noise at low wind speeds, the method enables more accurate environmental noise impact assessments. This directly supports the development of evidence-based regulatory policies and guidelines. Using long-term acoustic monitoring and an unsupervised Gaussian Mixture Model (GMM) clustering approach, we classified and excluded insect noise from recorded data. We found that the presence of cricket calls can increase measured wind turbine sound power levels (WTSPL) by more than 3 dBA at wind speeds below 6 m/s, with peak deviations reaching up to 10 dBA. These findings have significant implications for rural or low-wind regions where turbine operation at partial load is frequent. Our results underscore the importance of insect noise filtering when performing WTN assessments to ensure regulatory accuracy, particularly when long-term average noise modeling is used for compliance. The presented methodology provides a robust framework for distinguishing insect noise and can improve the consistency and credibility of WTN measurements under real-world environmental conditions.