The results of geoacoustic emission investigations carried out on the seismoactive Kamchatka Peninsula since 1999 are presented. The experiments are characterized by the application of broadband piezoceramic sound receivers (hydrophones) for recording the emission. The hydrophones were installed at the bottom of natural and artificial water reservoirs. As compared with the standard hydrophones, such receivers allow us to broaden the registration frequency range up to 0.1 Hz–11 kHz. Three-component vector receivers with the same frequency range were used simultaneously to study the spatial structure of the geoacoustic emission and the mode of the medium particle movement in a wave. In the course of the investigations, it was established that anomalies of the geoacoustic emission in the kilohertz frequency range are recorded 1–3 days before strong earthquakes at a distance of a few hundred kilometers from the epicenter. A sharp increase in the amplitude and frequency of the geoacoustic impulses, which resemble microearthquakes in pattern and last from tens of minutes to several hours, is interpreted as an anomaly. Signals at such frequencies cannot propagate from the epicenters of preparing earthquakes and represent the response of the medium at the registration point to the change of its stress-strain state. The stress field created therein determines the primary orientation of the emission sources, which can be assessed by vector-phase methods. The results of the integrated investigations of the geoacoustic emission and the Earth’s surface deformation revealed that anomalies are observed before earthquakes with a considerable increase in the strain rate during both the compression and extension of the near-surface rocks.
The paper describes a new adaptive approach to the investigation of acoustic emission of rocks, the anomalies of which may serve as short-term precursors of strong earthquakes. The basis of the approach is complex methods for monitoring acoustic emission and for analysis of its time-frequency content. Piezoceramic hydrophones and vector receivers, installed at the bottom of natural and artificial water bodies, as well as in boreholes with water, are used as acoustic emission sensors. To perform a time-frequency analysis of geoacoustic signals, we use a sparse approximation based on the developed Adaptive Matching Pursuit algorithm. The application of this algorithm in the analysis makes it possible to adapt to the concrete characteristics of each geoacoustic pulse. Results of the application of the developed approach for the investigation of acoustic emission anomalies, occurring before earthquakes, are presented. We analyzed the earthquakes, that occurred from 2011 to 2016 in the seismically active region of the Kamchatka peninsula, which is a part of the circum-Pacific orogenic belt also known as the “Ring of Fire”. It was discovered that geoacoustic pulse frequency content changes before a seismic event and returns to the initial state after an earthquake. That allows us to make a conclusion on the transformation of acoustic emission source scales before earthquakes. The obtained results may be useful for the development of the systems for environmental monitoring and detection of earthquake occurrences.
Application of acoustic emission of the sound frequency range is under consideration. This range is of current interest for the diagnostics of the stability of mountain slopes, glaciers, ice covers, large technical constructions (bridges, dams, etc.) as well as for the detection of rock deformation anomalies preceding earthquakes. Acoustic sensors, which can be used to record and to determine the directivity of acoustic emission of the sound frequency range, are under consideration. The structure of the system for acoustic emission recording, processing and analysis is described. This system makes it possible to determine the direction to the acoustic emission source using one multi-component sensor. We also consider the algorithms for detection of acoustic emission pulses in a noisy background, and for the analysis of their structure using the Adaptive Matching Pursuit algorithm. A method for the detection of the direction to an acoustic emission signal source based on multi-component sensors is described. The results of application of sound range acoustic emission for the detection of the intensification of rock deformations, associated with earthquake preparation and development in the seismically active region of Kamchatka peninsula, are presented.
Studies of geoacoustic emission in a seismically active region in Kamchatka show that geoacoustic signals produce pronounced pulse anomalies during the earthquake preparation and post-seismic relaxation of the local stresses field at the observation point. The qualitative selection of such anomalies is complicated by a strong distortion and weakening of the signal amplitude. A review of existing acoustic emission analysis methods shows that most often researchers turn to the analysis of more accessible to study statistical properties and energy of signals. The distinctive features of the approach proposed by the authors are the extraction of informative features based on the analysis of time and frequency-time structures of geoacoustic signals and the description of various forms of recognizable pulses by a limited pattern set. This study opens up new ideas to develop methods for detecting anomalous behavior of geoacoustic signals, including anomalies before earthquakes. The paper describes a technique of information extraction from geoacoustic emission pulse streams of sound frequency range. A geoacoustic pulse mathematical model, reflecting the signal generation process from a variety of elementary sources, is presented. A solution to the problem of detection of geoacoustic signal informative features is presented by the means of description of signal fragments by the matrixes of local extrema amplitude ratios and of interval ratios between them. The result of applying the developed algorithm to describe automatically the structure of the detected pulses and to form a pattern set is shown. The patterns characterize the features of geoacoustic emission signals observed at IKIR FEB RAS field stations. A technique of reduction of the detected pulse set dimensions is presented. It allows us to find patterns similar in structure. A solution to the problem of processing of a large data flow by unifying pulses description and their systematization is proposed. A method to identify a geoacoustic emission pulse model using sparse approximation schemes is suggested. An algorithmic solution of the problem of reducing the computational complexity of the matching pursuit method is described. It is to include an iterative refinement algorithm for the solution at each step in the method. The results of the research allowed the authors to create a tool to investigate the dynamic properties of geoacoustic emission signal in order to develop earthquake prediction detectors.
24 September 2019 in Izvestiya, Physics of the Solid Earth
Based on the integration and analysis of the published theoretical results and field observations, the possibility is considered of a joint perturbation in geoacoustic emission, radon,...
5 December 2022 in Вестник КРАУНЦ. Физико-математические науки
Статья посвящена построению математической модели высокочастотной (от единиц до десятков килогерц) геоакустической эмиссии приповерхностных осадочных пород, регистрируемой на Камчатке. В основе модели лежит система связанных осцилляторов. Каждый осциллятор описывает дислокационный источник геоакустической эмиссии. Модель строится на основании предположения, что взаимодействие между источниками осуществляется только через излучение. В работе рассматриваются два взаимодействующих между собой дислокационных источника геоакустической эмиссии. Математическое описание этих источников представлено в виде системы двух дифференциальных уравнений второго порядка. Методом Розенброка найдены численные решения модели при различных значениях коэффициента связи между источниками, построены расчетные осциллограммы, спектры и фазовые траектории. Анализ решений показывает, что при увеличении коэффициента связи наблюдается устойчивый обмен энергией между осцилляторами. The article is devoted to mathematical modeling of high-frequency (from units to tens of kilohertz) geoacoustic emission of near-surface sedimentary rocks recorded in Kamchatka. Dislocation emission sources are located in the volume of rocks bounded by a hemisphere of radius 37 m centered at the registration point. A typical signal of high-frequency geoacoustic emission is a combination of relaxation pulses. These pulses are closest in shape to the Berlage pulses. The article proposes a mathematical model of high-frequency geoacoustic emission of near-surface sedimentary rocks in the form of a system of coupled oscillators. Each oscillator describes a dislocation source of geoacoustic emission. The interaction between the sources is carried out only through radiation. A system of two coupled oscillators is considered. The Rosenbrock method was used to find numerical solutions for different values of the coupling coefficient between sources. Oscillograms, spectra and phase trajectories of the process under consideration are constructed. An analysis of the solutions showed that as the coupling coefficient increases, a stable energy exchange between the oscillators is observed.