The results of geoacoustic emission investigations carried out on the seismoactive Kamchatka Peninsula since 1999 are presented. The experiments are characterized by the application of broadband piezoceramic sound receivers (hydrophones) for recording the emission. The hydrophones were installed at the bottom of natural and artificial water reservoirs. As compared with the standard hydrophones, such receivers allow us to broaden the registration frequency range up to 0.1 Hz–11 kHz. Three-component vector receivers with the same frequency range were used simultaneously to study the spatial structure of the geoacoustic emission and the mode of the medium particle movement in a wave. In the course of the investigations, it was established that anomalies of the geoacoustic emission in the kilohertz frequency range are recorded 1–3 days before strong earthquakes at a distance of a few hundred kilometers from the epicenter. A sharp increase in the amplitude and frequency of the geoacoustic impulses, which resemble microearthquakes in pattern and last from tens of minutes to several hours, is interpreted as an anomaly. Signals at such frequencies cannot propagate from the epicenters of preparing earthquakes and represent the response of the medium at the registration point to the change of its stress-strain state. The stress field created therein determines the primary orientation of the emission sources, which can be assessed by vector-phase methods. The results of the integrated investigations of the geoacoustic emission and the Earth’s surface deformation revealed that anomalies are observed before earthquakes with a considerable increase in the strain rate during both the compression and extension of the near-surface rocks.
Application of acoustic emission of the sound frequency range is under consideration. This range is of current interest for the diagnostics of the stability of mountain slopes, glaciers, ice covers, large technical constructions (bridges, dams, etc.) as well as for the detection of rock deformation anomalies preceding earthquakes. Acoustic sensors, which can be used to record and to determine the directivity of acoustic emission of the sound frequency range, are under consideration. The structure of the system for acoustic emission recording, processing and analysis is described. This system makes it possible to determine the direction to the acoustic emission source using one multi-component sensor. We also consider the algorithms for detection of acoustic emission pulses in a noisy background, and for the analysis of their structure using the Adaptive Matching Pursuit algorithm. A method for the detection of the direction to an acoustic emission signal source based on multi-component sensors is described. The results of application of sound range acoustic emission for the detection of the intensification of rock deformations, associated with earthquake preparation and development in the seismically active region of Kamchatka peninsula, are presented.
The example of linguistic processing of acoustic signals of a seismic event would be an information approach to the processing of non-stationary signals. The method for converting an acoustic signal into an information message is described by identifying repetitive self-similar patterns. The definitions of the event selection indicators in the symbolic recording of the acoustic signal are given. The results of processing an acoustic signal by a computer program realizing the processing of linguistic data are shown. Advantages and disadvantages of using software algorithms are indicated.
In July–October 2006 and 2007, combined measurements of geoacoustic emission in the range of 2.0–6.5 kHz, the electric field in the atmosphere near the ground, and meteorological values were carried out in Kamchatka. Using the nonparametric method of Spearman’s correlation analysis, the relationship between their average hourly values was examined. After excluding results of bad weather (rain, strong and moderate wind, low atmospheric pressure), a highly important negative relation between disturbances in geoacoustic emission and the electric field were detected. Most probably, it was caused by amplification of the strain of near-surface sedimentary rocks at the observation point during a seismotectonic process. The revealed relation is evidence for another manifestation of the lithosphere’s influence on surface atmosphere in a seismoactive region.
1 October 2007 in Journal of Volcanology and Seismology
A field instrument package was installed for synchronous measurements of acoustic emission in rocks at frequencies of 0.1–10000 Hz and the vertical gradient of electric potential in near-ground atmosphere. These investigations for the first time revealed a relationship between emission disturbances in the kilohertz frequency range due to deformation of near-surface rocks and the electric field. The relationship may be observed both during seismically quiet periods and at the final phase of earthquake precursory periods.
The paper considers the results of experiments on localization of the sources of geoacoustic radiation generated in near-surface sedimentary rocks. Geoacoustic signals from sources were recorded by a spaced sensor system consisting of two combined receivers and a hydrophone. The system was installed near the bottom of a natural water body (Mikizha lake) in Kamchatka. Radiation sources were located by two methods, a triangulation survey and estimation of the signal arrival time difference from spaced receivers. Coordinates for more than 40 sources were measured, and their space distribution was mapped. As the result of the experiment, it was stated that geoacoustic radiation sources are located in bottom rocks at the depths up to 2.20 ± 0.25 m at the distances of up to 8 ± 0.25 m. Localization of geoacoustic radiation sources is topical for projecting a new alarm system for the notification on the possibility of strong earthquake occurrence. The results of the analysis of the frequency of rock AE source generation and accurate estimation of their location will be the basis of this system.