Most biomolecules are biologically active only in water; hence, it is worth investigating whether THz spectra of biomolecules are affected by the combination of water molecules and biomolecules. In this report, by combining the sample cell with the THz-TDS system, the THz spectra of L-Arginine crystal as well as its hydrate and aqueous solution are measured. The experimental results show that L-Arginine crystal and its hydrate share the same three absorption peaks at 0.99, 1.46, and 1.7 THz, respectively. But the trend of characteristic absorption spectrum of L-arginine solution is almost identical to that of free water. Because the contents of free water and hydrated water are different in many diseased and normal tissues, the diseased tissues can be detected according to the difference in THz spectral information. The proposed approach provides a reliable means for the detection of pathological changes of active molecules and tissues.
8 June 2022 in IEEE Transactions on Electron Devices
The nonlinear gallium arsenide photoconductivity semiconductor switch (GaAs PCSS) can generate high-voltage and strong current electrical pulses with low light triggering at the order of microjoule. Due to the lock-on effect of the GaAs PCSS, the output pulsewidth is usually on the order of hundreds of nanoseconds or even tens of microseconds. This severely limits the application of nonlinear GaAs PCSS. This article presents the output pulsewidth modulation of nonlinear GaAs PCSS through the dual regulation of energy-storage capacitance and current-limiting resistance. When triggered by a pulse laser with a width of 10 ns and a single pulse energy of 200 $\mu \text{J}$ , the switch can output the minimum pulsewidth of 6.3 ns and the maximum pulsewidth of 196 ns. In the meantime, combined with the theoretical analysis of photon-activated charge domain (PACD), the electric field intensity of nonlinear GaAs PCSS is less than the threshold electric field of PACD, and the switch will be turned off quickly so that different pulsewidths can be output. The experimental results indicate that adding different current-limiting resistances and energy-storage capacitance in the circuit can control the electric field intensity so that different pulsewidths can be output.
In this paper, a three-layer GaAs photoconductive semiconductor switch (GaAs PCSS) is designed to withstand high voltage from 20 to 35 kV. The maximum avalanche gain and minimum on-state resistance of GaAs PCSS are 1385 and 0.58 Ω, respectively, which are the highest values reported to date. Finally, the influence of the bias voltage on the avalanche stability is analyzed. The stability of the GaAs PCSS is evaluated and calculated. The results show that the jitter values at the bias voltages of 30 kV and 35 kV are 164.3 ps and 106.9 ps, respectively. This work provides guidance for the design of semiconductor switches with high voltage and high gain.
In this paper, the output electric pulse characteristics of gallium arsenide photoconductive semiconductor switch(GaAs PCSS) with bias voltage of 20 kV and pulse width of about 100 ns are studied. By designing the reflection and transmission optical paths, the absorption rate of the trigger optical of the GaAs PCSS at a wavelength of 1064 nm was measured to be 24.8%. When the bias voltage is 16 kV-20 kV, the avalanche multiplication rates of carriers are calculated respectively. The relationship between the output current waveform and the residual charge in the energy storage capacitor is analyzed when the bias voltage is 20 kV. And the trend of GaAs PCSS electric field intensity and current waveform change with time. This research will be helpful for the application design of GaAs PCSS under the nonlinear mode with special requirements, and has important significance for the application of frontier science.
In this paper, the output electrical pulse width of semi-insulating gallium arsenide photoconductive semiconductor switch (SI-GaAs PCSS) is controlled by means of Blumlein pulse formation line. Under the condition that the bias voltage is 28 kV and the laser pulse width is 9.5 ns, the electric pulse width obtained by using high-power pulse system transmission is 10 ns and the output voltage is 23 kV. Based on the Blumlein pulse formation line theory, the output pulse width and transient impedance are analyzed. The results show that the holding time of carriers avalanche multiplication can be controlled.
27 October 2021 in IEEE Transactions on Electron Devices
To investigate the effect of photon-induced carrier transition mechanism on switch stability, the time jitters of 2-mm-gap gallium arsenide photoconductive semiconductor switches (GaAs PCSSs) are compared when triggered by lasers of two different wavelengths, i.e., 1064 and 532 nm. The time jitter model is proposed to clarify the synergy of the multiple adjustable macroparameters of trigger conditions. The carrier valley occupation rates with respect to bias electric field are simulated, where the influence of the microprocedures, i.e., carrier generation, carrier intervalley transition, and carrier transportation, is considered. Our experimental results illustrate that the time jitter of the GaAs PCSS exhibits a nonmonotonous behavior and obtains a local minimum at ~3 kV/cm for 1064 nm; however, it shows a monotonous decrease to a constant value at about 3 kV/cm for 532 nm. Our analysis indicates that the discrepancy in GaAs PCSS time jitter is attributed to the difference in the relative fluctuation of the carrier velocity affected by the carrier valley occupation rate. This article is of great significance in optimizing the stability of GaAs PCSS and pulse power system by adjusting the macroparameters in the time jitter model.