Wear (erosion/abrasion) and corrosion act in synergy in several industrial installations where corrosive fluids circulate together with a solid phase causing mutual damage. High entropy alloys (HEAs) are promising materials to be used in that type of environments because of their outstanding chemical, electrochemical and mechanical properties. While several review articles are currently available on corrosion, mechanical properties, development of HEAs, microstructure, and HEA coatings, there is an undeniable lack of a comprehensive and critical review focusing on the tribological behaviour and tribocorrosion of bulk HEAs. This work aims to collect, summarise, and critically review the major accomplishments and progresses of HEAs over the last 20 years dealing with wear, corrosion, and wear-corrosion resistance. It highlights the most significant aspects that can influence the performance of HEAs including the change of the base alloying elements, the influence of the temperature, heat treatment, and wear test parameters (load, velocity, duration, distance). Furthermore, operating mechanisms, together with the relationship between microstructure and wear resistance, and between microstructure and corrosion resistance will be described. Finally, the articles that have been reported in the literature dealing with tribocorrosion of HEAs will be reviewed. The results of this study are expected to guide potential researchers and provide them with the sum of current trends in HEAs in terms of corrosion resistance, wear resistance and the synergy of both, in the hope of helping them to make the right decision to design and develop new HEAs or improve the research on the existing ones.

We report on the fabrication of efficient organic distributed feedback (DFB) lasers with thermally-nanoimprinted active films, emitting between 565 and 580 nm. The use of thermal-NIL has allowed, as opposed to room temperature or solvent-assisted techniques, high grating quality and excellent modulation depth. The 155°C heat exposure of the NIL process, does not significantly affect the thermal and optical properties of the active material (polystyrene films doped with a perylenediimide derivative). These devices combine a simple and low-cost preparation method with good laser characteristics, i.e. thresholds of 1 μJ/pulse, single-mode emission with linewidths below 0.2 nm and photostability half-lives of ~ 10⁵ pump pulses under ambient conditions. In comparison to more standard DFBs with gratings on the substrate, their fabrication is much easier, while they show a similar laser performance.