Yishan Zeng

Prof. Dr. Yishan Zeng


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 January 2025 in Journal of Biomechanics
Verified
Journal Article
Closed access
WGWenzhi Gao
Wenzhi Gao
CYChunzhen Yin
Chunzhen Yin
CZChunze Zhou
Chunze Zhou
DCDelei Cheng
Delei Cheng
JCJian Chen
Jian Chen
YZYishan Zeng
Yishan Zeng

21 December 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
JCJian Chen
Jian Chen
FMFanci Meng
Fanci Meng
ZFZihan Feng
Zihan Feng
WGWenzhi Gao
Wenzhi Gao
CLChanghai Liu
Changhai Liu
YZYishan Zeng
Yishan Zeng
This paper proposes to improve the output performance of a piezoelectric pump by matching the resonant frequency of the resonator to the optimal operating mode of bridge-type polydimethylsiloxane (PDMS) check valves. Simulation analyses reveal that the side-curling mode of the PDMS valve is conducive to liquid flow and exhibits a faster frequency response compared with the first bending mode. The first bending resonant frequency of a beam-type piezoelectric resonator was tuned close to the side-curling mode of the PDMS valve by adjusting the weight of two mass blocks installed on both ends of the resonator, so that both the resonator and the valve could work at their best conditions. Experiments were conducted on a detachable prototype piezoelectric pump using PDMS valves with three different lengths. The results confirm that the peak flowrate at the resonant point of the pump reaches its maximum when the resonant frequencies between the resonator and the valve are matched. Maximum peak flowrates of 88 mL/min, 72 mL/min and 70 mL/min were achieved at 722 Hz, 761 Hz and 789 Hz, respectively, for diaphragm pumps using five-, four- and three-inlet-hole PDMS valves, under a driving voltage of 300 Vpp.

16 September 2022 in Atmosphere
Verified
Journal Article
Open access
PDF file
HYHao Yan
Hao Yan
SLShisong Liu
Shisong Liu
FWFei Wang
Fei Wang
WXWei Xu
Wei Xu
JLJian Li
Jian Li
YZYishan Zeng
Yishan Zeng
A vital component that is frequently employed in the industrial powder conveying sector is the fluidized bed. In the light of powder unloading with a fluidized bed as the research object, an orthogonal experiment with two factors and four levels was established for the structural parameters of the fluidized bed. In the case of different noise factors, 16 schemes are designed and all schemes via computational fluid dynamics numerical simulation. The Taguchi method and regression analysis are used to analyze the response. Finally, the accuracy of the optimization results is tested. The results show that gas velocity decreases sharply at the airway’s entrance and, then, gas flows to the second half of the airway and velocity decreases steadily and uniformly. Airway arc length L exerts a greater effect on the signal-to-noise ratio (SNR) than airway height H. The parameter combination of 180 mm L and 17 mm H for obtaining the optimal velocity distribution uniformity is determined. The test results indicate that the overall fluidization effect of the fluidized bed with the optimal parameters is better. The linked research findings can be used as a guide when designing a fluidized bed system for transporting comparable powder.