Zenan Ni

Dr. Zenan Ni


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 March 2022 in Scientific Reports
Verified
Journal Article
Open access
PDF file
ZNZenan Ni
Zenan Ni
XDXavier Djitcheu
Xavier Djitcheu
XGXiaoxu Gao
Xiaoxu Gao
JWJian Wang
Jian Wang
Huimin LiuHuimin Liu
Huimin Liu
QZQijian Zhang
Qijian Zhang
CO2reforming of CH4(CRM) is not only beneficial to environmental protection, but also valuable for industrial application. Different CeO2supports were prepared to investigate the matching between Ni and CeO2over Ni/CeO2and its effect on CRM. The physicochemical properties of Ni/CeO2-C (commercial CeO2), Ni/CeO2-H (hydrothermal method) as well as Ni/CeO2-P (precipitation method) were characterized by XRD, N2adsorption at − 196 °C, TEM, SEM–EDS, H2-TPR, NH3-TPD and XPS. Ni0with good dispersion and CeO2with more oxygen vacancies were obtained on Ni/CeO2-H, proving the influence on Ni/CeO2catalysts caused by the preparation methods of CeO2. The initial conversion of both CO2and CH4of Ni/CeO2-H was more than five times that of Ni/CeO2-P and Ni/CeO2-C. The better matching between Ni and CeO2on Ni/CeO2-H was the reason for its best catalytic performance in comparison with the Ni/CeO2-C and Ni/CeO2-P samples.

13 March 2023 in Catalysts
Verified
Journal Article
Open access
PDF file
ZNZenan Ni
Zenan Ni
QWQiuwen Wang
Qiuwen Wang
YGYuxin Guo
Yuxin Guo
Huimin LiuHuimin Liu
Huimin Liu
QZQi-Jian Zhang
Qi-Jian Zhang
Photocatalysis technology is a potential solution to solve the problem of environmental pollution and energy shortage, but its wide application is limited by the low efficiency of solar energy conversion. As a non-toxic and inexpensive n-type semiconductor, WO3 can absorb approximately 12% of sunlight which is considered one of the most attractive photocatalytic candidates. However, the narrow light absorption range and the high recombination rate of photogenerated electrons and holes restrict the further development of WO3-based catalysts. Herein, the studies on preparation and modification methods such as doping element, regulating defects and constructing heterojunctions to enlarge the range of excitation light to the visible region and slow down the recombination of carriers on WO3-based catalysts so as to improve their photocatalytic performance are reviewed. The mechanism and application of WO3-based catalysts in the dissociation of water, the degradation of organic pollutants, as well as the hydrogen reduction of N2 and CO2 are emphatically investigated and discussed. It is clear that WO3-based catalysts will play a positive role in the field of future photocatalysis. This paper could also provide guidance for the rational design of other metallic oxide (MOx) catalysts for the increasing conversion efficiency of solar energy.

21 May 2025 in Russian Journal of General Chemistry
Verified
Journal Article
Closed access
PDF file
Yuxin GuoYuxin Guo
Yuxin Guo
WYW. Ya
W. Ya
SCS. Cheng
S. Cheng
ZNZenan Ni
Zenan Ni
RZR. Zhang
R. Zhang
Photocatalytic CO2 reduction is considered a promising green approach that can concurrently achieve sustainable energy production and mitigate climate change. However, the sluggish reaction kinetics and the complexity of multiple reaction pathways present substantial challenges to enhancing product generation rates and selectivity. Among various catalysts, layered double hydroxides (LDHs), as anion intercalation materials, have garnered considerable attention due to their ultrathin layered structure, tunable chemical composition, and modifiable transition metal d-electron configuration. These properties endow LDHs with broad spectral absorption, efficient carrier migration, and abundant active sites. In recent years, a considerable body of research has emerged focusing on LDHs catalyst; however, comprehensive reviews and summaries of these advancements remain scarce. This paper aims to systematically review the progress in regulating LDH structures for enhanced photocatalytic CO2 reduction. It begins by introducing the photocatalytic CO2 reduction mechanism and the structural characteristics of LDH photocatalysts. Subsequently, it summarizes methods for modifying the electronic structure of LDH photocatalysts through defect engineering, morphology control, single-atom modification, element doping, and heterojunction construction. These optimizations could improve light absorption, electron-hole separation and migration, and surface reduction reactions, thereby enhancing photocatalytic performance. Finally, the paper addresses the challenges faced by LDH photocatalytic systems and outlines future research directions.

1 March 2024 in Russian Journal of General Chemistry
Verified
Journal Article
Closed access
PDF file
RZR. Zhang
R. Zhang
ZNZenan Ni
Zenan Ni
JLJ. Li
J. Li
CHC. Hao
C. Hao
JWJ. Wang
J. Wang
QZQ. Zhang
Q. Zhang
Hydrogen energy has been widely accepted as renewable and clean energy source. However, safety problems exist in the process of hydrogen energy transportation and storage. On-site hydrogen production has great potential to solve safety problems, and dimethyl ether (DME) is an excellent hydrogen carrier. There are four ways for hydrogen production from DME, and they are DME steam reforming, partial oxidation of DME, autothermal reforming of DME, and plasma reforming of DME, respectively. Catalysts are essential for the first three reactions and the last one could achieve the activation of DME just through election catalysis. To the best of our knowledge, a review of hydrogen production from DME has not been reported, which should be discussed systematically. In this review, the advantages and disadvantages of different DME reforming processes are discussed, and the progress of catalysts for the reforming processes as well as the effects of catalysts in the reactions are summarized. This paper also provides the rational design of highly efficient catalysts on DME in the future.

1 August 2025 in Russian Journal of General Chemistry
Verified
Journal Article
Closed access
PDF file
Yuxin GuoYuxin Guo
Yuxin Guo
WYW. Ya
W. Ya
SCS. Cheng
S. Cheng
ZNZenan Ni
Zenan Ni
RZR. Zhang
R. Zhang
YLY. Luo
Y. Luo
With the escalating global focus on environmental and energy challenges, the conversion and utilization of CO2 have emerged as a pivotal research area. Numerous researchers are actively engaged in the conversion of CO2 to CO, a process that offers both climatic and economic advantages, thereby demonstrating substantial developmental potential. Catalysis utilizing photo-thermal energy has demonstrated the capability to achieve efficient CO2 conversion at reduced temperatures. Currently, there is a lack of consensus regarding the potential reaction mechanisms linking the structure and performance of catalysts, and review articles in this field are relatively limited. In this paper, we systematically review the design, synthesis, and underlying mechanisms of catalysts utilized in CO2 photothermal catalytic reactions for the past ten years, providing valuable insights and guidance for the development of highly efficient photothermal catalysts.

1 September 2025 in Russian Journal of General Chemistry
Verified
Journal Article
Closed access
PDF file
SCS. Cheng
S. Cheng
ZNZenan Ni
Zenan Ni
YGY. Guo
Y. Guo
QWQ. Wang
Q. Wang
JLJ. Li
J. Li
RZR. Zhang
R. Zhang
Propane dehydrogenation to propylene (PDH) represents a crucial process in propylene production, exhibiting extensive industrial application potential. In recent years, cobalt-based catalysts have garnered significant attention in PDH research due to their advantages such as relatively low cost, abundant active components, and tunability. This paper reviews the research progress of cobalt-based catalysts in PDH. Active cobalt can exist in various forms within the catalyst, including single-atomic Co that can precisely regulate propane adsorption and activation, prevalent tetrahedral Co(II) sites that interact significantly with the support material, and even metallic Co particles. However, the industrial application of cobalt-based catalysts still faces substantial challenges, including high-temperature deactivation of active sites, unclear carbon deposition kinetics, and excessive costs associated with large-scale synthesis. To address these issues, this paper systematically discusses strategies for enhancing catalyst performance, including adjustment of the active site microenvironment (additive doping and support modification), optimization of the catalyst interface (acid-base balance adjustment and pore structure design), and improvement of catalyst stability (multi-component synergistic strengthening). In addition, considering the challenges faced in the PDH reaction using Co-based catalysts, we summarize the corresponding regulatory strategies, providing novel insights and valuable guidance for the development of efficient PDH catalysts.