An absolute thermal lens method to determine fluorescence quantum efficiency and concentration quenching of solids is described in this work. The quantum efficiency of low silica calcium aluminate glasses doped with different concentrations of neodymium dioxide and melted under vacuum conditions to remove water has been measured by using mode-mismatched thermal lens spectrometry. It has been shown that the thermal lens signal amplitude is linearly dependent on neodymium concentrations up to 4.0 wt %, changing significantly from 4.5 to 5.0 wt %, indicating that there was quenching of the fluorescence only above 4.0 wt % neodymium dioxide. The quantitative treatment for the thermal lens effect provided the absolute value of the sample’s fluorescence quantum efficiency. The technique is simple to perform and can be applied for a wide range of fluorescent materials.

We present a single beam Z-scan technique using an intense, broadband, white-light continuum (WLC) beam for the direct measurement of nonlinear absorption spectra. In order to demonstrate the validity of our technique, we compared the results of tetraaniline and Sudan 3 solutions obtained with WLC and conventional single wavelength light sources. Both approaches lead to the same nonlinear spectrum, indicating that the association of the Z-scan technique and the WLC source results in an useful method for the measurement of nonlinear spectra of both absorbing (saturable absorption or reverse saturable absorption) and transparent (two-photon absorption) samples.

A multiwavelength thermal lens (TL) method was developed to determine the fluorescence quantum efficiency of solids. The experiments have been performed in Nd3+-doped fluoride glasses, using five different excitation wavelengths: 514, 576, 741, 796, and 867 nm. In this work, the absolute value of fluorescence quantum efficiency can be obtained by the linear dependence of the TL signal with the excitation wavelength. Our results suggest that the method can be applied to study a wide range of fluorescent materials, with a special ability to be used for measurements of highly transparent materials with very low TL effect.