Alperen UĞURLUOĞLU

Mr. Alperen UĞURLUOĞLU

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 December 2024 in International Advanced Researches and Engineering Journal
Verified
Journal Article
Open access
AUAlperen UĞURLUOĞLU
Alperen UĞURLUOĞLU
AKAhmet Karaarslan
Ahmet Karaarslan
Studies in literature and the increasing trend of electrification show that electric vehicles (EVs) will become more widespread in the future. However, the growing demand for EV chargers causes an overload on the grid. Furthermore, EV chargers generate power factor distortion and harmonics, which contaminate the grid and lower the quality of power. Therefore, power factor correction (PFC) is applied by EV chargers to mitigate the harmonics. As defined in the IEC 61000-3-2 standard, the total harmonic distortion (THD) shall be less than 5%. In this study, a better PFC operation is achieved with the proposed bridgeless isolated single ended primary inductor converter (BL SEPIC) topology as an EV charger instead of conventional converter topologies that have diode bridge rectifiers (DBR). Also, the study has better THD outputs as compared with the similar bridgeless (BL) topologies in literature thanks to the simulated control methods of the proportion-integration (PI) and fuzzy control. Moreover, these control methods are compared with each other in terms of THD suppression performance, stability, robustness, and computational effort. The results showed that the fuzzy controller has advantages of stability and robustness against the transient conditions, input voltages and load changes for THD suppression while the PI controller has better THD results only for steady state operation with nominal input voltage and full load conditions. The implemented PI and fuzzy controllers are simulated in a MATLAB Simulink environment.

30 September 2024 in Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji
Verified
Journal Article
Open access
PDF file
AUAlperen UĞURLUOĞLU
Alperen UĞURLUOĞLU
AKAhmet Karaarslan
Ahmet Karaarslan
This paper proposes a faster active package to cell (P2C) balancing battery management system (BMS) by using a proportion-integration (PI) controlled isolated CUK converter (ICC) with a cell-selective switch matrix (SWM). The high power capability of the ICC and a SWM that has the ability to select each cell individually or multiple cells in series increase balance speed. In addition, the low cost analysis and small size comparisons of the proposed study are presented. BMS is applied to battery packs to monitor the voltage, current, temperature, and state of charge (SoC) values of each cell and provide the battery pack with the ability to operate in a safe zone. One of the battery problems is that each battery cell in the pack does not contribute energy equally to the entire pack. Li-ion batteries that are used in this paper also suffer from this problem due to their higher energy density than other batteries. Therefore, a balancing operation is needed for the voltage and SoC of each cell. According to the average of battery cells, the entire pack charges the selected lower cells by converting the energy through ICC and switching the lower energized cells. Due to the isolation, the energy can be transferred from pack to cell. The proposed study is simulated in MATLAB Simulink and then implemented experimentally. The experimental studies produce a balancing speed of 9.64 mV/min with 81.98% efficiency. Finally, the result of the proposed study is compared with the other P2C methods in the literature. The comparison also showed that the proposed study is a cost effective solution.