The partial replacement of primary raw materials for the production of refractories with recycled ones gains in importance, as it contributes to the conservation of natural resources, energy saving, and reduction in greenhouse gas emissions. In this work, the use of a magnesia–carbon (MgO-C) recyclate in the fractions 3–6, 1–3, and 0–1 mm as a raw material for MgO-C refractories was investigated. The recyclate was examined via optical and scanning electron microscopy. Using mixtures with different recyclate contents up to 82 wt%, MgO-C specimens were prepared to study the influence of the recyclate on their chemical composition, structure, and properties. The substitution of primary raw materials with the recyclate did not cause a decrease in the MgO content analyzed after carbon burnout, but the contents of the individual impurities changed. A comparison of the MgO-C that contains 82 wt% recyclate with the recyclate-free material through computed tomography indicated a change in the size distribution of the MgO grains. The porosity increased, and the cold modulus of rupture decreased with increasing recyclate content, whereas the thermal shock resistance improved. At a recyclate content of 40 wt%, the refractoriness under load was only slightly lower than that of the recyclate-free material.
Recycling of used refractories – in particular closed‐loop recycling – gains in importance because of both ecological and economic benefits, such as the conservation of natural resources, reduced landfilling, and the reduction of greenhouse gases and energy consumption. In this work, the use of a magnesia‐carbon (MgO‐C) recyclate for the production of MgO‐C refractories is investigated. Using fused magnesia, the mentioned MgO‐C recyclate, graphite, novolak, and a modified coal tar pitch, test specimens with different recyclate contents (0, 40, 65, and 82 wt%) were prepared on a laboratory scale. The apparent porosity, which is usually higher in recyclate‐based refractories than in recyclate‐free ones, increased by 14% from the specimens made exclusively from virgin raw materials to those made from the mixture containing 82 wt% recyclate. The dynamic Young's modulus and cold modulus of rupture decreased, but the thermal shock resistance was improved by the use of the recyclate.