Graphene nanoplatelets (GNP) were exfoliated using a nondestructive chemical reduction method and subsequently decorated with polymers using two different approaches: grafting from and grafting to. Poly(methyl methacrylate) (PMMA) with varying molecular weights was covalently attached to the GNP layers using both methods. The grafting ratios were higher (44.6% to 126.5%) for the grafting from approach compared to the grafting to approach (12.6% to 20.3%). The products were characterized using thermogravimetric analysis–mass spectrometry (TGA-MS), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), atomic force microscopy (AFM), and transmission electron microscopy (TEM). The grafting from products showed an increase in the grafting ratio and dispersibility in acetone with increasing monomer supply; on the other hand, due to steric effects, the grafting to products showed lower absolute grafting ratios and a decreasing trend with increasing polymer molecular weight. The excellent dispersibility of the grafting from functionalized graphene, 900 μg/mL in acetone, indicates an increased compatibility with the solvent and the potential to increase graphene reinforcement performance in nanocomposite applications.

A non-destructive and versatile chemical reduction method was used to dissolve and subsequently brominate few-layer graphene sheets (FLGs). The brominated FLGs provide a convenient precursor for the synthesis of a variety of directly functionalised graphenes.

Graphite intercalation compounds (GICs) are often used to produce exfoliated or functionalised graphene related materials (GRMs) in a specific solvent. This study explores the formation of the Na‐tetrahydrofuran (THF)‐GIC and a new ternary system based on dimethylacetamide (DMAc). Detailed comparisons of in situ temperature dependent XRD with TGA‐MS and Raman measurements reveal a series of dynamic transformations during heating. Surprisingly, the bulk of the intercalation compound is stable under ambient conditions, trapped between the graphene sheets. The heating process drives a reorganisation of the solvent and Na molecules, then an evaporation of the solvent; however, the solvent loss is arrested by restacking of the graphene layers, leading to trapped solvent bubbles. Eventually, the bubbles rupture, releasing the remaining solvent and creating expanded graphite. These trapped dopants may provide useful property enhancements, but also potentially confound measurements of grafting efficiency in liquid‐phase covalent functionalization experiments on 2D materials.

Protein crystallization remains a major bottleneck for the determination of high resolution structures. Nucleants can accelerate the process but should ideally be compatible with high throughput robotic screening. Polyethylene glycol grafted (PEGylated) graphenes can be stabilized in water providing dispensable, nucleant systems. Two graphitic feedstocks are exfoliated and functionalized with PEG using a non‐destructive, scalable, chemical reduction method, delivering good water dispersibility (80 and 750 µg mL⁻¹ for large and small layers, respectively). The wide utility of these nucleants has been established across five proteins and three different screens, each of 96 conditions, demonstrating greater effectiveness of the dispersed PEGylated graphenes. Smaller numbers of larger, more crystalline flakes consistently act as better protein nucleants. The delivered nucleant concentration is optimized (0.1 mg mL⁻¹ in the condition), and the performance benchmarked against existing state of the art, molecularly imprinted polymer nucleants. Strikingly, graphene nucleants are effective even when decreasing both the nucleant and protein concentration to unusually low concentrations. The set‐up to scale‐up nucleant production to liter volumes can provide sufficient material for wide implementation. Together with the optimized crystallization conditions, the results are a step forward toward practical synthesis of a readily accessible “universal” nucleant.