Michal Kaczmarek

Prof. Dr. Michal Kaczmarek

Institute of Mechatronics and Information Systems, Lodz University of Technology, 90-924 Lodz, Poland
orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 June 2020 in IEEE Access
Verified
Journal Article
Open access
Michal KaczmarekMichal Kaczmarek
Michal Kaczmarek
ESErnest Stano
Ernest Stano
The novelty of the paper contributes to the increase of the reliability of the methods used for evaluation of the inductive CTs accuracy of transformation of the distorted current. The results of performed analyses shows that the values of current and phase errors of transformation of the low order higher harmonics by inductive CT depends significantly from the phase angle between transformed higher harmonics of the distorted primary current and the self-generated higher harmonics of the secondary current. Moreover, higher harmonics of the distorted primary current may increase the peak value of the magnetic flux density in the magnetic core. Then the impact of the self-generated low order harmonics resulting from the nonlinearity of the magnetic core on values of current and phase errors of transformation of the higher harmonics of the distorted primary current is increased. Proposed evaluation procedure enables determination of the maximum values of current and phase errors of transformation of the higher harmonics of the distorted primary current. It is essential to determine the accuracy class. In such approach the impact of the secondary current’s distortion caused by the nonlinearity of the magnetic core and the influence of the harmonic distortion on the peak value of the magnetic flux density are considered. Therefore, transformation accuracy of tested CT is ensured for specified range and type of the load of the secondary winding, rms values of primary current and its distortion.

1 December 2019 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
Michal KaczmarekMichal Kaczmarek
Michal Kaczmarek
ESErnest Stano
Ernest Stano


1 September 2017 in Electric Power Systems Research
Verified
Journal Article
Closed access
Michal KaczmarekMichal Kaczmarek
Michal Kaczmarek

11 April 2020 in Sensors
Verified
Journal Article
Open access
PDF file
ESErnest Stano
Ernest Stano
Michal KaczmarekMichal Kaczmarek
Michal Kaczmarek
Self-calibration of a designed wideband inductive current transformer (CT) was carried out in the ampere-turns condition. This method does not require a reference transducer. The values of current and phase errors at the harmonics of frequencies from 100 Hz to 5 kHz were determined for the distorted primary current of the rated main frequency equal to 50 Hz. These results were verified based on the comparison of values measured between two CTs and calculated as the difference between values obtained from their calibration. Moreover, from vectorial diagrams drawn for transformation of the higher harmonics, the source of the change in the values of current and phase errors with frequency is explained. Furthermore, the method for calculation of the values of the corresponding harmonics of the current associated with the active power losses in the core and the magnetization current is presented.