The aim of this work is to structurally characterize chitosan-zinc oxide nanoparticles (CS-ZnO NPs) films in a wide range of NPs concentration (0–20 wt.%). Dielectric, conductivity, mechanical, and piezoelectric properties are assessed by using thermogravimetry, FTIR, XRD, mechanical, and dielectric spectroscopy measurements. These analyses reveal that the dielectric constant, Young’s modulus, and piezoelectric constant (d₃₃) exhibit a strong dependence on nanoparticle concentration such that maximum values of referred properties are obtained at 15 wt.% of ZnO NPs. The piezoelectric coefficient d₃₃ in CS-ZnO nanocomposite films with 15 wt.% of NPs (d₃₃ = 65.9 pC/N) is higher than most of polymer-ZnO nanocomposites because of the synergistic effect of piezoelectricity of NPs, elastic properties of CS, and optimum NPs concentration. A three-phase model is used to include the chitosan matrix, ZnO NPs, and interfacial layer with dielectric constant higher than that of neat chitosan and ZnO. This layer between nanoparticles and matrix is due to strong interactions between chitosan’s side groups with ZnO NPs. The understanding of nanoscale properties of CS-ZnO nanocomposites is important in the development of biocompatible sensors, actuators, nanogenerators for flexible electronics and biomedical applications.

Bipolar plates (BPs) are one of the most important components of polymer electrolyte membrane fuel cells (PEMFCs) because of their important role in gas and water management, electrical performance, and mechanical stability. Therefore, promising materials for use as BPs should meet several technical targets established by the United States Department of Energy (DOE). Thus far, in the literature, many materials have been reported for possible applications in BPs. Of these, polymer composites reinforced with carbon allotropes are one of the most prominent. Therefore, in this review article, we present the progress and critical analysis on the use of carbon material-reinforced polymer composites as BPs materials in PEMFCs. Based on this review, it is observed that numerous polymer composites reinforced with carbon allotropes have been produced in the literature, and most of the composites synthesized and characterized for their possible application in BPs meet the DOE requirements. However, these composites can still be improved before their use for BPs in PEMFCs.

The study of novel materials for H₂ storage is essential to consolidate the hydrogen as a clean energy source. In this sense, the H₂ adsorption on Pd_4-nNi_n (n = 0–3) clusters embedded on pyridinic-type N-doped graphene (PNG) was investigated using density functional theory calculations. First, the properties of Pd_4-nNi_n (n = 0–3) clusters embedded on PNG were analyzed in detail. Then, the H₂ adsorption on these composites was computed. The E_int between the Pd_4-nNi_n (n = 0–3) clusters and the PNG was greater than that computed in the literature for Pd-based systems embedded on pristine graphene. Consequently, it was deduced that PNG can more significantly stabilize the Pd_4-nNi_n (n = 0–3) clusters. The analyzed composites exhibited a HOMO–LUMO gap less than 1 eV, indicating good reactivity. Based on the E_ads of H₂ on Pd_4-nNi_n (n = 0–3) clusters embedded on PNG, it was observed that the analyzed systems meet the standards set by the DOE. Therefore, these composites can be viable alternatives for hydrogen storage.