The main factors that influence the properties of composite are fiber length and content. Hence the prediction of optimum fiber length and content becomes important, so that composite can be prepared with best mechanical properties. Experiments are carried out as per ASTM standards to find the mechanical properties namely, tensile strength and modulus, flexural strength and modulus, and impact strength. In addition to mechanical properties, water absorption capacity of the composite is also studied. Further, fractured surface of the specimen are subjected to morphological study using scanning electron microscope. The investigation revealed the suitability of banana fiber as an effective reinforcement in epoxy matrix.
Composites can be divided into three groups based on their matrix materials, namely polymer, metal and ceramic. Composite materials fail due to micro cracks. Repairing is complex and almost impossible if cracks appear on the surface and interior, which minimizes reliability and material life. In order to save the material from failure and prolong its lifetime without compromising mechanical properties, self-healing is one of the emerging and best techniques. The studies to address the advantages and challenges of self-healing properties of different matrix materials are very limited; however, this review addresses all three different groups of composites. Self-healing composites are fabricated to heal cracks, prevent any obstructed failure, and improve the lifetime of structures. They can self-diagnose their structure after being affected by external forces and repair damages and cracks to a certain degree. This review aims to provide information on the recent developments and prospects of self-healing composites and their applications in various fields such as aerospace, automobiles etc. Fabrication and characterization techniques as well as intrinsic and extrinsic self-healing techniques are discussed based on the latest achievements, including microcapsule embedment, fibers embedment, and vascular networks self-healing.
This present study focuses on evaluation of mechanical properties of three dimensional (3D)-printed carbon fiber/polylactic acid (CF/PLA) composites, using fused deposition modeling (FDM) technique. The composites were prepared with different slicing parameters: layer heights or thicknesses, infill densities and layer patterns. The 3D-printed composite samples were subjected to tensile, flexural and interlaminar shear strength (ILSS) tests to assess the influence of the process parameters on their mechanical characteristics. Further investigations were carried out to evaluate the effect of surface roughness of the samples. From the test results, it was evident that both rectilinear and hexagonal layer patterns exhibited better mechanical properties at infill density and layer thickness of 60% and 0.64 mm, respectively. The scanning electron microscopy (SEM) images depicted that lesser layer thickness produced poor CF/PLA interfacial bonding and major failure mode was traced to fiber pull-out. Therefore, engineering application of the composite samples depends on their slicing parameters.
30 April 2013 in Journal of Reinforced Plastics and Composites
The natural fiber-reinforced composites are emerging as a possible replacement to glass fiber composite for low-cost applications. Of the various machining process, drilling is one of the most common machining processes used for the assemblage of various parts. During drilling process, composites undergo delamination phenomenon that reduces the structural reliability of the component. The present work focuses on the analysis of delamination behaviour as a function of drilling process parameters at the entrance and exit of the composite plates. In this work, drilling was carried out by varying the feed (0.1, 0.2, 0.3 mm/rev) and speed (500, 1000, 1500 and 2000 r/min), respectively. The drill bit used is made of high-speed steel of a diameter of 10 mm. The quality of the hole drilled was assessed using the machine vision technique, and the extent of delamination was carried out using the ultrasonic C-scan imaging method. The experimentally observed delamination factor was compared with ANOVA technique and found that the feed rate affect the delamination than speed. A correlation between the parameters of interest was carried out using multi-variable linear regression analysis technique.